From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peter Subject: Re: sound problem (was: [no subject]) Date: Sat, 07 Feb 2004 15:48:15 +0800 Sender: linux-newbie-owner@vger.kernel.org Message-ID: <20040207074815.935E51C945@heisspf> References: <5.1.0.14.1.20040206093637.01fa5758@celine> Mime-Version: 1.0 Return-path: In-Reply-To: Your message of "Fri, 06 Feb 2004 09:58:33 PST." <5.1.0.14.1.20040206093637.01fa5758@celine> List-Id: Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Ray Olszewski Cc: linux-newbie@vger.kernel.org Thanks! I made it, I have now normal sound in Slackware 9.1 First I did make modules, then make modules_install after which I had no more sound. Doing /sbin/insmod soundcore it spit back no such file. Then I found that there is no .../drivers/sound folder. I copied it over from RedHat9. Did insmod soundcore, ac97_codec, via82cxxx_audio and all sounded normally. Then I put those insmod commands into rc.local. Using modprobe I get error no such file soundcore etc. I do not know if this is a professional solution, but it works. Now to some of your questions: In RedHat xconfig Sound has only one setting, sound card support yes. That is what I put in Slackware and put 'no' on all the other settings which were there. When you mentioned OSS I put that on 'yes' in SW. ray@comarre.com said: > Your problem in Slackware may simply be that you have not used amixer > or alsamixer to configure the sound modules correctly I tried tried all kinds of different settings on alsamixer before I went on the list. According to Richard of pa3gcu my problem is well know of ALSA drivers. ray@comarre.com said: > though we customarily treat all 2.4.22 (for example) kernel sources > as the same in these discussions, that is not exactly true As I mentioned I took the SW kernel 2.4.22 from the Slackware Installation Disk and installed it in RH9 and even in RH7.3. Therefore, I assume that they are the same. In RH7.3 I had the kernel 2.4.18-7 and could open siag office. When I installed RH9.0 with kernel 2.4.18-9 siag office would not open; don't ask me why and by now I forgot the error message. Since siag office opens in SW9.1 with kernel 2.4.22 I put that kernel into RH9.0 and siag office runs again. Thanks to your help and patience I am almost ready to fully switch to SW9.1. Sorry for my sometimes not too professional descriptions of facts. Regards -- Peter - To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.linux-learn.org/faqs