From mboxrd@z Thu Jan  1 00:00:00 1970
From: Nishanth Aravamudan <nacc@us.ibm.com>
Date: Mon, 26 Jul 2004 23:55:41 +0000
Subject: [Kernel-janitors] [PATCH] net/e100: replace schedule_timeout() with
Message-Id: <20040726235541.GI1897@us.ibm.com>
MIME-Version: 1
Content-Type: multipart/mixed; boundary="===============24708937799215347=="
List-Id: <kernel-janitors.vger.kernel.org>
To: kernel-janitors@vger.kernel.org

--===============24708937799215347==
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline

I would appreciate any comments from the janitors list. This is one (of
many) cases where I made a decision about replacing

set_current_state(TASK_INTERRUPTIBLE);
schedule_timeout(some_time);

with

msleep(jiffies_to_msecs(some_time));

msleep() is not exactly the same as the previous code, but I only did
this replacement where I thought long delays were *desired*. If this is
not the case here, then just disregard this patch. 

Thanks,
Nish



Applys-to: 2.6.7

Description: Replace schedule_timeout() with msleep() to guarantee the
task delays for the desired time.


--- linux-vanilla/drivers/net/e100.c	2004-06-16 05:20:26.000000000 +0000
+++ linux-dev/drivers/net/e100.c	2004-07-12 18:59:43.000000000 +0000
@@ -613,8 +613,7 @@ static int e100_self_test(struct nic *ni
 	writel(selftest | dma_addr, &nic->csr->port);
 	e100_write_flush(nic);
 	/* Wait 10 msec for self-test to complete */
-	set_current_state(TASK_UNINTERRUPTIBLE);
-	schedule_timeout(HZ / 100 + 1);
+	msleep(10);
 
 	/* Interrupts are enabled after self-test */
 	e100_disable_irq(nic);
@@ -662,9 +661,8 @@ static void e100_eeprom_write(struct nic
 			e100_write_flush(nic); udelay(4);
 		}
 		/* Wait 10 msec for cmd to complete */
-		set_current_state(TASK_UNINTERRUPTIBLE);
-		schedule_timeout(HZ / 100 + 1);
-
+		msleep(10);
+		
 		/* Chip deselect */
 		writeb(0, &nic->csr->eeprom_ctrl_lo);
 		e100_write_flush(nic); udelay(4);
@@ -1734,8 +1732,7 @@ static int e100_loopback_test(struct nic
 	memset(skb->data, 0xFF, ETH_DATA_LEN);
 	e100_xmit_frame(skb, nic->netdev);
 
-	set_current_state(TASK_UNINTERRUPTIBLE);
-	schedule_timeout(HZ / 100 + 1);
+	msleep(10);
 
 	if(memcmp(nic->rx_to_clean->skb->data + sizeof(struct rfd),
 	   skb->data, ETH_DATA_LEN))
@@ -1821,8 +1818,7 @@ static void e100_get_regs(struct net_dev
 			mdio_read(netdev, nic->mii.phy_id, i);
 	memset(nic->mem->dump_buf, 0, sizeof(nic->mem->dump_buf));
 	e100_exec_cb(nic, NULL, e100_dump);
-	set_current_state(TASK_UNINTERRUPTIBLE);
-	schedule_timeout(HZ / 100 + 1);
+	msleep(10);
 	memcpy(&buff[2 + E100_PHY_REGS], nic->mem->dump_buf,
 		sizeof(nic->mem->dump_buf));
 }
@@ -1987,8 +1983,7 @@ static int e100_phys_id(struct net_devic
 	if(!data || data > (u32)(MAX_SCHEDULE_TIMEOUT / HZ))
 		data = (u32)(MAX_SCHEDULE_TIMEOUT / HZ);
 	mod_timer(&nic->blink_timer, jiffies);
-	set_current_state(TASK_INTERRUPTIBLE);
-	schedule_timeout(data * HZ);
+	msleep(data * 1000);
 	del_timer_sync(&nic->blink_timer);
 	mdio_write(netdev, nic->mii.phy_id, MII_LED_CONTROL, 0);
 

--===============24708937799215347==
Content-Type: text/plain; charset="iso-8859-1"
MIME-Version: 1.0
Content-Transfer-Encoding: quoted-printable
Content-Disposition: inline

_______________________________________________
Kernel-janitors mailing list
Kernel-janitors@lists.osdl.org
http://lists.osdl.org/mailman/listinfo/kernel-janitors

--===============24708937799215347==--