Re: raid 1 - automatic 'repair' possible?

[Jakob Oestergaard <jakob@unthought.net>]

On Wed, Jan 19, 2005 at 11:48:52AM +0100, Kiniger wrote:
...
> some random thoughts:
> 
> nowadays hardware sector sizes are much bigger than 512 bytes

No :)

> and
> the read error may affect some sectors +- the sector which actually
> returned the error.

That's right

> 
> to keep the handling in userspace as much as possible: 
> 
> the real problem is the long resync time. therefore it would
> be sufficient to have a concept of "defective areas" per partition
> and drive (a few of them, perhaps four or so , would be enough) 
> which will be excluded from reads/writes and some means to
> re-synchronize these "defective areas" from the good counterparts
> of the other disk. This would avoid having the whole partition being
> marked as defective.

I wonder if it's really worth it.

The original idea has some merit I think - but what you're suggesting
here is almost "bad block remapping" with transparent recovery and user
space policy agents etc. etc.

If a drive has problems reading the platter, it can usually be corrected
by overwriting the given sector (either the drive can actually overwrite
the sector in place, or it will re-allocate it with severe read
performance penalties following). But there's a reason why that sector
went bad, and you realy want to get the disk replaced.

I think the current policy of marking the disk as failed when it has
failed is sensible.

Just my 0.02 Euro

-- 

 / jakob