[-mm patch] SIS190 must select MII

[Adrian Bunk <bunk@stusta.de>]

On Tue, Aug 09, 2005 at 02:26:31AM +0200, Jiri Slaby wrote:
> Hello, i find out this problem:
> #make O=../bu allmodconfig
> ...
> #make O=../bu all
> ...
>  LD      .tmp_vmlinux1
> drivers/built-in.o(.text+0x63c87): In function `sis190_get_settings':
> /l/latest/xxx/drivers/net/sis190.c:1656: undefined reference to 
> `mii_ethtool_gset'
>...

Obvious bug in git-netdev-sis190.patch, fix below.

cu
Adrian


<--  snip  -->


SIS190 must select MII since it's using it.

While I was editing the Kconfig entry, I also converted the spaces to 
tabs.


Signed-off-by: Adrian Bunk <bunk@stusta.de>

--- linux-2.6.13-rc5-mm1-full/drivers/net/Kconfig.old	2005-08-09 02:32:14.000000000 +0200
+++ linux-2.6.13-rc5-mm1-full/drivers/net/Kconfig	2005-08-09 02:33:12.000000000 +0200
@@ -1924,14 +1924,15 @@
 	  If in doubt, say Y.
 
 config SIS190
-      tristate "SiS190 gigabit ethernet support"
-      depends on PCI
-      select CRC32
-      ---help---
-        Say Y here if you have a SiS 190 PCI Gigabit Ethernet adapter.
+	tristate "SiS190 gigabit ethernet support"
+	depends on PCI
+	select CRC32
+	select MII
+	---help---
+	  Say Y here if you have a SiS 190 PCI Gigabit Ethernet adapter.
 
-        To compile this driver as a module, choose M here: the module
-        will be called sis190.  This is recommended.
+	  To compile this driver as a module, choose M here: the module
+	  will be called sis190.  This is recommended.
 
 config SKGE
 	tristate "New SysKonnect GigaEthernet support (EXPERIMENTAL)"