Re: [PATCH] Use todc on Mot PReP platforms

[Sven Luther <sven.luther@wanadoo.fr>]

On Mon, Aug 15, 2005 at 10:52:24PM -0700, Matt Porter wrote:
> On Thu, Aug 11, 2005 at 12:43:07PM -0700, Tom Rini wrote:
> > On Wed, Aug 10, 2005 at 09:37:35AM -0700, Matt Porter wrote:
> > 
> > > This restores behavior from 2.4 where PReP platforms identified
> > > as Motorola would calibrate the decrementer using the RTC. On
> > > real Motorola PReP hardware this isn't needed. However, in order
> > > to boot a stock 2.6 PReP kernel on qemu (which emulates a Motorola
> > > PReP system) it is necessary to allow it to calibrate the decrementer
> > > using an emulated RTC.  If the decrementer rate is read from
> > > residual data then timing is screwed since a qemu PReP system typically
> > > runs much faster than the original hardware.
> > > 
> > > If anybody has objections to this as the default, let me know. It
> > > still works (as did 2.4) on a couple of my Mot PReP boxes and doesn't
> > > affect the IBM PReP paths. My goal with this is to be able to run
> > > a stock 2.6 defconfig PReP build on qemu.
> > 
> > So, I like this, and not just because I'm playing with qemu as well.
> 
> Why? It has no other redeeming quality except that it makes qemu work.
> It's better to use residual data versus todc calibration in real machine
> cases since residual data is accurate for this particular value on these
> machines. I'm just curious why you would like this patch outside of
> its qemu value.
> 
> BTW, it's _possible_ that we might eventually modify the open
> hackware OF to do a timing loop and dynamically fill in the
> residual data time base freq but that's unfamiliar territory and
> this is an easy workaround.

What about modifying qemu's OF to emulate a chrp machine instead ?

Friendly,

Sven Luther