[ipw2200] add monitor and qos entries to Kconfig

[Andreas Happe <andreashappe@snikt.net>]

Add the following config entries for the ipw2200 driver to
drivers/net/wireless/Kconfig
 * IPW2200_MONITOR
   enables Monitor mode
 * IPW2200_QOS
   enables QoS feature - this is under development right now, so it depends 
   upon EXPERIMENTAL

driver compiles and enters monitor mode.

Signed-off-by: Andreas Happe <andreashappe@snikt.net>
--- drivers/net/wireless/Kconfig.orig	2006-01-05 18:30:10.000000000 +0100
+++ drivers/net/wireless/Kconfig	2006-01-05 18:30:13.000000000 +0100
@@ -217,6 +217,19 @@ config IPW2200
           say M here and read <file:Documentation/modules.txt>.  The module
           will be called ipw2200.ko.
 
+config IPW2200_MONITOR
+        bool "Enable promiscuous mode"
+        depends on IPW2200
+        ---help---
+	  Enables promiscuous/monitor mode support for the ipw2200 driver.
+	  With this feature compiled into the driver, you can switch to 
+	  promiscuous mode via the Wireless Tool's Monitor mode.  While in this
+	  mode, no packets can be sent.
+
+config IPW2200_MONITOR
+        bool "Enable QoS support"
+        depends on IPW2200 && EXPERIMENTAL
+
 config IPW_DEBUG
 	bool "Enable full debugging output in IPW2200 module."
 	depends on IPW2200