Re: [PATCH 02/22] Firmware interface code for IB device.

[Christoph Hellwig <hch@infradead.org>]

On Fri, Feb 17, 2006 at 04:57:07PM -0800, Roland Dreier wrote:
> From: Roland Dreier <rolandd@cisco.com>
> 
> This is a very large file with way too much code for a .h file.
> The functions look too big to be inlined also.  Is there any way
> for this code to move to a .c file?
> ---
> 
>  drivers/infiniband/hw/ehca/hcp_if.h | 2022 +++++++++++++++++++++++++++++++++++

> +#include "ehca_tools.h"
> +#include "hipz_structs.h"
> +#include "ehca_classes.h"
> +
> +#ifndef EHCA_USE_HCALL
> +#include "hcz_queue.h"
> +#include "hcz_mrmw.h"
> +#include "hcz_emmio.h"
> +#include "sim_prom.h"
> +#endif
> +#include "hipz_fns.h"
> +#include "hcp_sense.h"
> +#include "ehca_irq.h"
> +
> +#ifndef CONFIG_PPC64
> +#ifndef Z_SERIES
> +#warning "included with wrong target, this is a p file"
> +#endif
> +#endif
> +
> +#ifdef EHCA_USE_HCALL
> +
> +#ifndef EHCA_USERDRIVER
> +#include "hcp_phyp.h"
> +#else
> +#include "testbench/hcallbridge.h"
> +#endif
> +#endif

the ifdefs should all go away and the build system should make sure it's
only built for the right platforms.