From mboxrd@z Thu Jan 1 00:00:00 1970 From: jordan.crouse@amd.com (Jordan Crouse) Date: Thu, 27 Apr 2006 14:43:41 +0000 Subject: [lm-sensors] making a geode i2c slave driver Message-Id: <20060427144341.GE15384@cosmic.amd.com> List-Id: References: <20060427092159.GA27959@grok.co.za> In-Reply-To: <20060427092159.GA27959@grok.co.za> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org On 27/04/06 09:31 -0400, Mark M. Hoffman wrote: > Another alternative would be to implement support for SMBALERT#. This is > basically a third wire that acts as an interrupt signal from slave to > master. At the moment, there is no support for it in the I2C core, but > it could be added... and it may be easier than adding host-as-slave > support (if your hardware can support SMBALERT#). I don't think the 1100 has specific support for that, but you could always plug it into an unused GPIO, I would think, and process the interrupt from there. Jordan -- Jordan Crouse Senior Linux Engineer AMD - Personal Connectivity Solutions Group