From: Deepak Saxena <dsaxena@plexity.net>
To: Alessandro Zummo <alessandro.zummo@towertech.it>
Cc: Andrew Morton <akpm@osdl.org>,
linux-kernel@vger.kernel.org, rmk@arm.linux.org.uk
Subject: Re: [PATCH] Add driver for ARM AMBA PL031 RTC
Date: Tue, 16 May 2006 17:01:42 -0700 [thread overview]
Message-ID: <20060517000142.GA23236@plexity.net> (raw)
In-Reply-To: <20060517010259.5a035b20@inspiron>
Updated patch follows:
Signed-off-by: Deepak Saxena <dsaxena@plexity.net>
diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig
index 65d090d..875ff5e 100644
--- a/drivers/rtc/Kconfig
+++ b/drivers/rtc/Kconfig
@@ -157,6 +157,16 @@ config RTC_DRV_VR41XX
To compile this driver as a module, choose M here: the
module will be called rtc-vr41xx.
+config RTC_DRV_PL031
+ tristate "ARM AMBA PL031 RTC"
+ depends on RTC_CLASS && ARM_AMBA
+ help
+ If you say Y here you will get access to ARM AMBA
+ PrimeCell PL031 UART found on certain ARM SOCs.
+
+ To compile this driver as a module, choose M here: the
+ module will be called rtc-pl031.
+
config RTC_DRV_TEST
tristate "Test driver/device"
depends on RTC_CLASS
diff --git a/drivers/rtc/Makefile b/drivers/rtc/Makefile
index a9ca0f1..1b3f32e 100644
--- a/drivers/rtc/Makefile
+++ b/drivers/rtc/Makefile
@@ -20,3 +20,4 @@ obj-$(CONFIG_RTC_DRV_M48T86) += rtc-m48t
obj-$(CONFIG_RTC_DRV_EP93XX) += rtc-ep93xx.o
obj-$(CONFIG_RTC_DRV_SA1100) += rtc-sa1100.o
obj-$(CONFIG_RTC_DRV_VR41XX) += rtc-vr41xx.o
+obj-$(CONFIG_RTC_DRV_PL031) += rtc-pl031.o
diff --git a/drivers/rtc/rtc-pl031.c b/drivers/rtc/rtc-pl031.c
new file mode 100644
index 0000000..3598df9
--- /dev/null
+++ b/drivers/rtc/rtc-pl031.c
@@ -0,0 +1,233 @@
+/*
+ * drivers/rtc/rtc-pl031.c
+ *
+ * Real Time Clock interface for ARM AMBA PrimeCell 031 RTC
+ *
+ * Author: Deepak Saxena <dsaxena@plexity.net>
+ *
+ * Copyright 2006 (c) MontaVista Software, Inc.
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License
+ * as published by the Free Software Foundation; either version
+ * 2 of the License, or (at your option) any later version.
+ */
+
+#include <linux/platform_device.h>
+#include <linux/module.h>
+#include <linux/rtc.h>
+#include <linux/init.h>
+#include <linux/fs.h>
+#include <linux/interrupt.h>
+#include <linux/string.h>
+#include <linux/pm.h>
+
+#include <linux/amba/bus.h>
+
+#include <asm/io.h>
+#include <asm/bitops.h>
+#include <asm/hardware.h>
+#include <asm/irq.h>
+#include <asm/rtc.h>
+
+/*
+ * Register definitions
+ */
+#define RTC_DR 0x00 /* Data read register */
+#define RTC_MR 0x04 /* Match register */
+#define RTC_LR 0x08 /* Data load register */
+#define RTC_CR 0x0c /* Control register */
+#define RTC_IMSC 0x10 /* Interrupt mask and set register */
+#define RTC_RIS 0x14 /* Raw interrupt status register */
+#define RTC_MIS 0x18 /* Masked interrupt status register */
+#define RTC_ICR 0x1c /* Interrupt clear register */
+
+struct pl031_local {
+ struct rtc_device *rtc;
+ void __iomem *base;
+};
+
+static irqreturn_t pl031_interrupt(int irq, void *dev_id, struct pt_regs *regs)
+{
+ struct rtc_device *rtc = (struct rtc_device *)dev_id;
+
+ rtc_update_irq(&rtc->class_dev, 1, RTC_AF);
+
+ return IRQ_HANDLED;
+}
+
+static int pl031_open(struct device *dev)
+{
+ /*
+ * We request IRQ in pl031_probe, so nothing to do here...
+ */
+ return 0;
+}
+
+static void pl031_release(struct device *dev)
+{
+}
+
+static int pl031_ioctl(struct device *dev, unsigned int cmd, unsigned long arg)
+{
+ struct pl031_local *ldata = dev_get_drvdata(dev);
+
+ switch (cmd) {
+ case RTC_AIE_OFF:
+ __raw_writel(1, ldata->base + RTC_MIS);
+ return 0;
+ case RTC_AIE_ON:
+ __raw_writel(0, ldata->base + RTC_MIS);
+ return 0;
+ }
+
+ return -ENOIOCNTLCMD;
+}
+
+static int pl031_read_time(struct device *dev, struct rtc_time *tm)
+{
+ struct pl031_local *ldata = dev_get_drvdata(dev);
+
+ rtc_time_to_tm(__raw_readl(ldata->base + RTC_DR), tm);
+
+ return 0;
+}
+
+static int pl031_set_time(struct device *dev, struct rtc_time *tm)
+{
+ unsigned long time;
+ struct pl031_local *ldata = dev_get_drvdata(dev);
+
+ rtc_tm_to_time(tm, &time);
+ __raw_writel(time, ldata->base + RTC_LR);
+
+ return 0;
+}
+
+static int pl031_read_alarm(struct device *dev, struct rtc_wkalrm *alarm)
+{
+ struct pl031_local *ldata = dev_get_drvdata(dev);
+
+ rtc_time_to_tm(__raw_readl(ldata->base + RTC_MR), &alarm->time);
+ alarm->pending = __raw_readl(ldata->base + RTC_RIS);
+ alarm->enabled = __raw_readl(ldata->base + RTC_IMSC);
+
+ return 0;
+}
+
+static int pl031_set_alarm(struct device *dev, struct rtc_wkalrm *alarm)
+{
+ struct pl031_local *ldata = dev_get_drvdata(dev);
+ unsigned long time;
+
+ rtc_tm_to_time(&alarm->time, &time);
+
+ __raw_writel(time, ldata->base + RTC_MR);
+ __raw_writel(!alarm->enabled, ldata->base + RTC_MIS);
+
+ return 0;
+}
+
+static struct rtc_class_ops pl031_ops = {
+ .open = pl031_open,
+ .release = pl031_release,
+ .ioctl = pl031_ioctl,
+ .read_time = pl031_read_time,
+ .set_time = pl031_set_time,
+ .read_alarm = pl031_read_alarm,
+ .set_alarm = pl031_set_alarm,
+};
+
+static int pl031_remove(struct amba_device *adev)
+{
+ struct pl031_local *ldata = dev_get_drvdata(&adev->dev);
+
+ if (ldata) {
+ dev_set_drvdata(&adev->dev, NULL);
+ free_irq(adev->irq[0], ldata->rtc);
+ rtc_device_unregister(ldata->rtc);
+ iounmap(ldata->base);
+ kfree(ldata);
+ }
+
+ return 0;
+}
+
+static int pl031_probe(struct amba_device *adev, void *id)
+{
+ int ret;
+ struct pl031_local *ldata;
+
+
+ ldata = kmalloc(sizeof(struct pl031_local), GFP_KERNEL);
+ if (!ldata) {
+ ret = -ENOMEM;
+ goto out;
+ }
+ dev_set_drvdata(&adev->dev, ldata);
+
+ ldata->base = ioremap(adev->res.start,
+ adev->res.end - adev->res.start + 1);
+ if (!ldata->base) {
+ ret = -ENOMEM;
+ goto out_no_remap;
+ }
+
+ if (request_irq(adev->irq[0], pl031_interrupt, SA_INTERRUPT,
+ "rtc-pl031", ldata->rtc)) {
+ ret = -EIO;
+ goto out_no_irq;
+ }
+
+ ldata->rtc = rtc_device_register("pl031", &adev->dev, &pl031_ops,
+ THIS_MODULE);
+ if (IS_ERR(ldata->rtc)) {
+ ret = PTR_ERR(ldata->rtc);
+ goto out_no_rtc;
+ }
+
+ return 0;
+
+out_no_rtc:
+ free_irq(adev->irq[0], ldata->rtc);
+out_no_irq:
+ iounmap(ldata->base);
+out_no_remap:
+ dev_set_drvdata(&adev->dev, NULL);
+ kfree(ldata);
+out:
+ return ret;
+}
+
+static struct amba_id pl031_ids[] __initdata = {
+ {
+ .id = 0x00041031,
+ .mask = 0x000fffff, },
+ {0, 0},
+};
+
+static struct amba_driver pl031_driver = {
+ .drv = {
+ .name = "rtc-pl031",
+ },
+ .id_table = pl031_ids,
+ .probe = pl031_probe,
+ .remove = pl031_remove,
+};
+
+static int __init pl031_init(void)
+{
+ return amba_driver_register(&pl031_driver);
+}
+
+static void __exit pl031_exit(void)
+{
+ amba_driver_unregister(&pl031_driver);
+}
+
+module_init(pl031_init);
+module_exit(pl031_exit);
+
+MODULE_AUTHOR("Deepak Saxena <dsaxena@plexity.net");
+MODULE_DESCRIPTION("ARM AMBA PL031 RTC Driver");
+MODULE_LICENSE("GPL");
--
Deepak Saxena - dsaxena@plexity.net - http://www.plexity.net
I am not a consumer. My existence on this planet is not defined by my
relationship to a producer of goods. I was not put on this planet to
consume goods from a company for their profit. - Michael W.
next prev parent reply other threads:[~2006-05-16 23:59 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2006-05-16 21:48 [PATCH] Add driver for ARM AMBA PL031 RTC Deepak Saxena
2006-05-16 23:02 ` Alessandro Zummo
2006-05-17 0:01 ` Deepak Saxena [this message]
2006-05-17 0:08 ` Alessandro Zummo
2006-06-10 1:45 ` Andrew Morton
2006-05-18 21:14 ` Deepak Saxena
2006-05-19 7:00 ` Alessandro Zummo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20060517000142.GA23236@plexity.net \
--to=dsaxena@plexity.net \
--cc=akpm@osdl.org \
--cc=alessandro.zummo@towertech.it \
--cc=linux-kernel@vger.kernel.org \
--cc=rmk@arm.linux.org.uk \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.