From: Voluspa <lista1@comhem.se>
To: wfg@mail.ustc.edu.cn
Cc: Valdis.Kletnieks@vt.edu, linux-kernel@vger.kernel.org
Subject: Re: Adaptive Readahead V14 - statistics question...
Date: Tue, 30 May 2006 05:36:31 +0200 [thread overview]
Message-ID: <20060530053631.57899084.lista1@comhem.se> (raw)
Sorry about the top-post, I'm not subscribed.
On 2006-05-30 0:37:57 Wu Fengguang wrote:
> On Mon, May 29, 2006 at 03:44:59PM -0400, Valdis Kletnieks wrote:
[...]
>> doing anything useful? (One thing I've noticed is that xmms, rather
>> than gobble up 100K of data off disk every 10 seconds or so, snarfs
>> a big 2M chunk every 3-4 minutes, often sucking in an entire song at
>> (nearly) one shot...)
>
> Hehe, it's resulted from the enlarged default max readahead size(128K
> => 1M). Too much aggressive? I'm interesting to know the recommended
> size for desktops, thanks. For now you can adjust it through the
> 'blockdev --setra /dev/hda' command.
And notebooks? I'm running a 64bit system with 2gig memory and a 7200
RPM disk. Without your patches a movie like Elephants_Dream_HD.avi
causes a continuous silent read. After patching 2.6.17-rc5 (more on that
later) there's a slow 'click-read-click-read-click-etc' during the
same movie as the head travels _somewhere_ to rest(?) between reads.
Distracting in silent sequences, and perhaps increased disk wear/tear.
I'll try adjusting the readahead size towards silence tomorrow.
But as size slides in a mainstream direction, whence will any benefit
come - in this Joe-average case? It's not a faster 'cp' at least:
_Cold boot between tests - Copy between different partitions_
2.6.17-rc5-proper (Elephants_Dream_HD.avi 854537054 bytes)
real 0m44.050s
user 0m0.076s
sys 0m6.344s
2.6.17-rc5-patched
real 0m49.353s
user 0m0.075s
sys 0m6.287s
2.6.17-rc5-proper (compiled kernel tree linux-2.6.17-rc5 ~339M)
real 0m47.952s
user 0m0.198s
sys 0m6.118s
2.6.17-rc5-patched
real 0m46.513s
user 0m0.200s
sys 0m5.827s
Of course, my failure to see speed-ups could well be 'cos of a botched
patch transfer (or some kind of missing groundwork only available in
-mm). There was one reject in particular which made me pause. I'm no
programmer... and 'continue;' is a weird direction. At the end I settled
on:
[mm/readahead.c]
@@ -184,8 +289,10 @@
page->index, GFP_KERNEL)) {
ret = mapping->a_ops->readpage(filp, page);
if (ret != AOP_TRUNCATED_PAGE) {
- if (!pagevec_add(&lru_pvec, page))
+ if (!pagevec_add(&lru_pvec, page)) {
+ cond_resched();
__pagevec_lru_add(&lru_pvec);
+ }
continue;
} /* else fall through to release */
}
The full 82K experiment can temprarily be found at this location:
http://web.comhem.se/~u46139355/storetmp/adaptive-readahead-v14-linux-2.6.17-rc5-part-01to28of32.patch
At least it hasn't eaten my (backed up) disk yet ;-)
Mvh
Mats Johannesson
--
next reply other threads:[~2006-05-30 3:36 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2006-05-30 3:36 Voluspa [this message]
2006-05-30 6:40 ` Adaptive Readahead V14 - statistics question Wu Fengguang
2006-05-30 6:40 ` Wu Fengguang
2006-05-30 16:49 ` Valdis.Kletnieks
2006-05-31 21:06 ` Diego Calleja
2006-05-31 21:50 ` Voluspa
2006-06-01 5:51 ` Fengguang Wu
2006-06-01 5:51 ` Fengguang Wu
2006-06-01 6:35 ` Voluspa
2006-06-08 8:04 ` Voluspa
2006-06-08 11:37 ` adaptive readahead overheads Fengguang Wu
2006-06-08 11:37 ` Fengguang Wu
2006-06-08 12:25 ` Voluspa
2006-06-08 12:39 ` Fengguang Wu
2006-06-08 12:39 ` Fengguang Wu
2006-06-08 13:05 ` Andi Kleen
2006-06-08 14:00 ` Jens Axboe
[not found] ` <448493E9.9030203@samwel.tk>
2006-06-06 3:34 ` Adaptive Readahead V14 - statistics question Wu Fengguang
2006-06-06 3:34 ` Wu Fengguang
-- strict thread matches above, loose matches on Subject: below --
2006-06-04 7:34 [PATCH] readahead: initial method - expected read size - fix fastcall Fengguang Wu
2006-06-04 7:34 ` Fengguang Wu
2006-06-04 9:07 ` Andrew Morton
2006-06-04 9:25 ` Arjan van de Ven
2006-06-05 1:17 ` Voluspa
2006-06-05 8:00 ` Arjan van de Ven
2006-06-06 2:26 ` Fengguang Wu
2006-06-06 2:26 ` Fengguang Wu
2006-06-08 7:31 ` Voluspa
2006-06-08 7:57 ` Fengguang Wu
2006-06-08 7:57 ` Fengguang Wu
2006-06-06 2:57 ` Fengguang Wu
2006-06-06 2:57 ` Fengguang Wu
2006-06-08 7:43 ` Voluspa
2006-06-08 8:13 ` Fengguang Wu
2006-06-08 8:13 ` Fengguang Wu
2006-06-08 8:28 ` Voluspa
2006-06-08 8:50 ` Fengguang Wu
2006-06-08 8:50 ` Fengguang Wu
2006-06-08 10:04 ` Voluspa
2006-06-04 12:13 ` [PATCH] readahead: call scheme - fix fastcall readahead_cache_hit() Fengguang Wu
2006-06-04 12:13 ` Fengguang Wu
2006-05-29 19:44 Adaptive Readahead V14 - statistics question Valdis.Kletnieks
2006-05-30 0:37 ` Wu Fengguang
2006-05-30 0:37 ` Wu Fengguang
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20060530053631.57899084.lista1@comhem.se \
--to=lista1@comhem.se \
--cc=Valdis.Kletnieks@vt.edu \
--cc=linux-kernel@vger.kernel.org \
--cc=wfg@mail.ustc.edu.cn \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.