[PATCH 07/13] e1000: Allow NVM to setup LPLU for IGP2 and IGP3

["Kok, Auke" <auke-jan.h.kok@intel.com>]

Allow NVM to setup LPLU for IGP2 and IGP3. Only IGP needs LPLU D3
disabled during init here.

Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com>
---

 drivers/net/e1000/e1000_hw.c |   13 ++++++++-----
 1 files changed, 8 insertions(+), 5 deletions(-)

diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c
index 583518a..3728f33 100644
--- a/drivers/net/e1000/e1000_hw.c
+++ b/drivers/net/e1000/e1000_hw.c
@@ -1324,11 +1324,14 @@ e1000_copper_link_igp_setup(struct e1000
     E1000_WRITE_REG(hw, LEDCTL, led_ctrl);
     }
 
-    /* disable lplu d3 during driver init */
-    ret_val = e1000_set_d3_lplu_state(hw, FALSE);
-    if (ret_val) {
-        DEBUGOUT("Error Disabling LPLU D3\n");
-        return ret_val;
+    /* The NVM settings will configure LPLU in D3 for IGP2 and IGP3 PHYs */
+    if (hw->phy_type == e1000_phy_igp) {
+        /* disable lplu d3 during driver init */
+        ret_val = e1000_set_d3_lplu_state(hw, FALSE);
+        if (ret_val) {
+            DEBUGOUT("Error Disabling LPLU D3\n");
+            return ret_val;
+        }
     }
 
     /* disable lplu d0 during driver init */



--
Auke Kok <auke-jan.h.kok@intel.com>