From: Olaf Hering <olaf@aepfle.de>
To: linux-kernel@vger.kernel.org
Subject: oops in aty128_bl_set_power in 2.6.18-rc5
Date: Tue, 29 Aug 2006 18:26:06 +0200 [thread overview]
Message-ID: <20060829162606.GA26378@aepfle.de> (raw)
This oops happes on a G4/466 when X blanks the screen.
date:~ # lsmod
Module Size Used by
snd_pcm_oss 61568 0
snd_mixer_oss 21376 1 snd_pcm_oss
snd_seq 68160 0
snd_seq_device 10028 1 snd_seq
r128 44740 2
drm 79992 3 r128
ipv6 291340 16
loop 19912 0
dm_mod 65424 0
ehci_hcd 35752 0
8139too 28032 0
sungem 34564 0
sungem_phy 10368 1 sungem
uninorth_agp 10728 1
mii 6560 1 8139too
uhci_hcd 32460 0
agpgart 36892 2 drm,uninorth_agp
ohci1394 39952 0
snd_aoa_i2sbus 23876 0
ieee1394 114352 1 ohci1394
snd_aoa_soundbus 7780 1 snd_aoa_i2sbus
ide_floppy 21728 0
ide_cd 47332 0
cdrom 43388 1 ide_cd
snd_powermac 50748 1
snd_pcm 99332 3 snd_pcm_oss,snd_aoa_i2sbus,snd_powermac
snd_timer 28292 2 snd_seq,snd_pcm
snd 73268 10 snd_pcm_oss,snd_mixer_oss,snd_seq,snd_seq_device,snd_aoa_i2sbus,snd_powermac,snd_pcm,snd_timer
soundcore 10980 1 snd
snd_page_alloc 11496 1 snd_pcm
...
Total memory = 256MB; using 512kB for hash table (at cff80000)
Linux version 2.6.18-rc5-default-mainline (olaf@pomegranate) (gcc version 4.1.0 (SUSE Linux)) #3 Tue Aug 29 16:41:44 CEST 2006
Found initrd at 0xc4100000:0xc4330000
Found UniNorth memory controller & host bridge @ 0xf8000000 revision: 0x11
Mapped at 0xfdfc0000
Found a Keylargo mac-io controller, rev: 3, mapped at 0xfdf40000
Processor NAP mode on idle enabled.
PowerMac motherboard: PowerMac G4 Silver
...
PCI: Enabling device 0000:00:10.0 (0086 -> 0087)
aty128fb: Invalid ROM signature 1111 should be 0xaa55
aty128fb: BIOS not located, guessing timings.
aty128fb: Rage128 PF PRO AGP [chip rev 0x1] 16M 128-bit SDR SGRAM (1:1)
Console: switching to colour frame buffer device 128x48
fb0: ATY Rage128 frame buffer device on Rage128 PF PRO AGP
...
eth1: Link is up at 100 Mbps, full-duplex.
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-devel@redhat.com
loop: loaded (max 8 devices)
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
eth0: link down
eth1: Link is up at 100 Mbps, full-duplex.
eth1: Pause is enabled (rxfifo: 10240 off: 7168 on: 5632)
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
ADDRCONF(NETDEV_UP): eth0: link is not ready
IPv6 over IPv4 tunneling driver
[drm] Initialized drm 1.0.1 20051102
[drm] Initialized r128 2.5.0 20030725 on minor 0
agpgart: Putting AGP V2 device at 0000:00:0b.0 into 1x mode
agpgart: Putting AGP V2 device at 0000:00:10.0 into 1x mode
audit(1156867816.177:2): audit_pid=3980 old=0 by auid=4294967295
Unable to handle kernel paging request for data at address 0x00000000
Faulting instruction address: 0xc01a62e8
Oops: Kernel access of bad area, sig: 11 [#1]
Modules linked in: snd_pcm_oss snd_mixer_oss snd_seq snd_seq_device r128 drm ipv6 loop dm_mod ehci_hcd 8139too sungem sungem_phy uninorth_agp mii uhci_hcd agpgart ohci1394 snd_aoa_i2sbus ieee1394 snd_aoa_soundbus ide_floppy ide_cd cdrom snd_powermac snd_pcm snd_timer snd soundcore snd_page_alloc
NIP: C01A62E8 LR: C01A62E4 CTR: C01A6544
REGS: cdf95cc0 TRAP: 0300 Not tainted (2.6.18-rc5-default-mainline)
MSR: 00009032 <EE,ME,IR,DR> CR: 28002422 XER: 20000000
DAR: 00000000, DSISR: 40000000
TASK = ced218f0[3081] 'X' THREAD: cdf94000
GPR00: C01A62E4 CDF95D70 CED218F0 00000000 00000004 00004611 00000002 10220000
GPR08: 00004611 CDF94000 FFFFFFE7 00000000 00000000 10228A14 10220000 10220F0C
GPR16: 7FCDE570 10220F0C 10220000 10220000 7FCDE318 7FCDE570 10230000 00000000
GPR24: 10220000 101F0000 10220000 00000007 FFFFFFED C42F0000 C42F0214 00000004
NIP [C01A62E8] aty128_bl_set_power+0x28/0x9c
LR [C01A62E4] aty128_bl_set_power+0x24/0x9c
Call Trace:
[CDF95D70] [C01A62E4] aty128_bl_set_power+0x24/0x9c (unreliable)
[CDF95D90] [C01A65A8] aty128fb_blank+0x64/0x120
[CDF95DB0] [C01706DC] fb_blank+0x4c/0x84
[CDF95DE0] [C01716C0] fb_ioctl+0x4e4/0x5c4
[CDF95ED0] [C00977A0] do_ioctl+0x6c/0x84
[CDF95EE0] [C0097B38] vfs_ioctl+0x380/0x3b4
[CDF95F10] [C0097BD4] sys_ioctl+0x68/0x98
[CDF95F40] [C0012480] ret_from_syscall+0x0/0x40
--- Exception: c01 at 0xfd75f48
LR = 0xfd75ee0
Instruction dump:
7c0803a6 4e800020 9421ffe0 7c0802a6 bfa10014 3bc30214 7c7d1b78 7fc3f378
90010024 7c9f2378 48125df1 807d0220 <7c001828> 30000001 7c00192d 40a2fff4
reply other threads:[~2006-08-29 16:26 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20060829162606.GA26378@aepfle.de \
--to=olaf@aepfle.de \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.