[PATCH] jmr3927: do not call tc35815_killall().

[Ralf Baechle <ralf@linux-mips.org>]

No need to stop tc35815 before resetting the board.  This fixes the
build of tc35815 as a module.  This also means there is no caller of
tc35815_killall left, so remove that function also.

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

diff --git a/arch/mips/jmr3927/rbhma3100/setup.c b/arch/mips/jmr3927/rbhma3100/setup.c
index 7ca3d6d..ecabe5b 100644
--- a/arch/mips/jmr3927/rbhma3100/setup.c
+++ b/arch/mips/jmr3927/rbhma3100/setup.c
@@ -137,10 +137,6 @@ int jmr3927_ccfg_toeon = 0;
 
 static inline void do_reset(void)
 {
-#ifdef CONFIG_TC35815
-	extern void tc35815_killall(void);
-	tc35815_killall();
-#endif
 #if 1	/* Resetting PCI bus */
 	jmr3927_ioc_reg_out(0, JMR3927_IOC_RESET_ADDR);
 	jmr3927_ioc_reg_out(JMR3927_IOC_RESET_PCI, JMR3927_IOC_RESET_ADDR);
diff --git a/drivers/net/tc35815.c b/drivers/net/tc35815.c
index 81ed82f..911ff51 100644
--- a/drivers/net/tc35815.c
+++ b/drivers/net/tc35815.c
@@ -1703,19 +1703,6 @@ static void tc35815_chip_init(struct net_device *dev)
 	spin_unlock_irqrestore(&lp->lock, flags);
 }
 
-/* XXX */
-void
-tc35815_killall(void)
-{
-	struct net_device *dev;
-
-	for (dev = root_tc35815_dev; dev; dev = ((struct tc35815_local *)dev->priv)->next_module) {
-		if (dev->flags&IFF_UP){
-			dev->stop(dev);
-		}
-	}
-}
-
 static struct pci_driver tc35815_driver = {
 	.name = TC35815_MODULE_NAME,
 	.probe = tc35815_probe,