From: "Dale Farnsworth" <dale@farnsworth.org>
To: Arnd Bergmann <arnd@arndb.de>
Cc: linuxppc-dev@ozlabs.org, Paul Mackerras <paulus@samba.org>
Subject: Re: [PATCH 9/13] powerpc: Add arch/powerpc mv64x60 I2C platform data setup
Date: Wed, 25 Apr 2007 23:08:55 -0700 [thread overview]
Message-ID: <20070426060855.GD2030@xyzzy.farnsworth.org> (raw)
In-Reply-To: <200704260402.17248.arnd@arndb.de>
On Thu, Apr 26, 2007 at 02:02:16AM +0000, Arnd Bergmann wrote:
> On Thursday 26 April 2007, Mark A. Greer wrote:
> > > location is the smaller part of the problem. Even if it was the right
> > > thing to scan the tree and then create platform_data instead of using
> > > the of_device, that code would still belong into the device driver.
> >
> > I don't think of_device is going to work very well on MIPS.
>
> Ok, I see your point there. But after looking at the i2c and net drivers,
> I believe that they can easily be split into an architecture dependent
> part that is either an of_platform_driver or a platform_driver, and
> a common part that does not know about either of these.
Oh, it's certainly possible, but it doesn't seem desirable to me. Why
should the drivers carry the burden of supporting both platform_driver
and of_platform_driver interfaces?
-Dale
next prev parent reply other threads:[~2007-04-26 6:08 UTC|newest]
Thread overview: 87+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-04-25 23:46 [PATCH 0/13] powerpc: Add support for Marvell/mv64x60 and prpmc2800 Mark A. Greer
2007-04-25 23:55 ` [PATCH 1/13] powerpc: Add Makefile rule to wrap dts file in zImage Mark A. Greer
2007-04-30 6:06 ` David Gibson
2007-04-25 23:55 ` [PATCH 2/13] powerpc: Add dt_xlate_addr() to bootwrapper Mark A. Greer
2007-04-26 16:44 ` Scott Wood
2007-04-27 5:55 ` Paul Mackerras
2007-04-27 20:48 ` Mark A. Greer
2007-04-25 23:56 ` [PATCH 3/13] powerpc: Add bootwrapper support for Marvell/mv64x60 hostbridge Mark A. Greer
2007-04-27 6:01 ` Paul Mackerras
2007-04-27 22:02 ` Mark A. Greer
2007-05-03 5:25 ` Paul Mackerras
2007-05-03 18:44 ` Mark A. Greer
2007-05-03 19:00 ` Mark A. Greer
2007-05-05 23:27 ` Paul Mackerras
2007-05-07 18:15 ` Mark A. Greer
2007-04-25 23:57 ` [PATCH 4/13] powerpc: Add bootwrapper support for Marvell MPSC Mark A. Greer
2007-04-25 23:57 ` [PATCH 5/13] powerpc: Add bootwrapper support for Marvell/mv64x60 I2C Mark A. Greer
2007-04-25 23:58 ` [PATCH 6/13] powerpc: Add arch/powerpc support for Marvell/mv64x60 hostbridge Mark A. Greer
2007-04-26 0:42 ` Arnd Bergmann
2007-04-26 5:49 ` Dale Farnsworth
2007-05-02 21:38 ` [PATCH 6/13] powerpc: Add arch/powerpc interrupt handler for mv64x60 Dale Farnsworth
2007-05-03 1:47 ` Stephen Rothwell
2007-05-03 2:55 ` Dale Farnsworth
2007-04-25 23:59 ` [PATCH 7/13] powerpc: Add arch/powerpc mv64x60 MPSC platform data setup Mark A. Greer
2007-04-26 0:14 ` Arnd Bergmann
2007-04-26 5:57 ` Dale Farnsworth
2007-04-26 11:24 ` Arnd Bergmann
2007-04-26 14:30 ` Dale Farnsworth
2007-04-26 15:14 ` Arnd Bergmann
2007-05-02 21:41 ` Dale Farnsworth
2007-05-03 6:40 ` Arnd Bergmann
2007-05-04 21:03 ` [PATCH 7/13] powerpc: Create Marvell mv64x60 MPSC (serial) platform_data Dale Farnsworth
2007-05-05 12:26 ` Arnd Bergmann
2007-04-26 0:00 ` [PATCH 8/13] powerpc: Add arch/powerpc mv64x60_eth platform data setup Mark A. Greer
2007-04-26 0:18 ` Arnd Bergmann
2007-04-26 6:00 ` Dale Farnsworth
2007-05-02 21:43 ` Dale Farnsworth
2007-05-03 2:03 ` Stephen Rothwell
2007-05-03 6:43 ` Arnd Bergmann
2007-05-04 21:06 ` [PATCH 8/13] powerpc: Create Marvell mv64x60 ethernet platform_data Dale Farnsworth
2007-05-05 12:28 ` Arnd Bergmann
2007-04-26 0:00 ` [PATCH 9/13] powerpc: Add arch/powerpc mv64x60 I2C platform data setup Mark A. Greer
2007-04-26 0:21 ` Arnd Bergmann
2007-04-26 0:43 ` Mark A. Greer
2007-04-26 0:55 ` Arnd Bergmann
2007-04-26 1:13 ` Mark A. Greer
2007-04-26 2:02 ` Arnd Bergmann
2007-04-26 6:08 ` Dale Farnsworth [this message]
2007-04-26 9:00 ` Arnd Bergmann
2007-04-26 14:19 ` Dale Farnsworth
2007-04-26 15:04 ` Arnd Bergmann
2007-04-27 23:50 ` Dale Farnsworth
2007-04-28 1:05 ` Arnd Bergmann
2007-04-28 2:40 ` Dale Farnsworth
2007-05-01 4:58 ` Paul Mackerras
2007-05-01 4:45 ` Paul Mackerras
2007-04-26 6:48 ` Mark A. Greer
2007-05-02 21:44 ` Dale Farnsworth
2007-05-03 6:53 ` Arnd Bergmann
2007-05-03 13:06 `
2007-05-04 21:08 ` [PATCH 9/13] powerpc: Create Marvell mv64x60 I2C platform_data Dale Farnsworth
2007-05-05 12:29 ` Arnd Bergmann
2007-04-26 0:01 ` [PATCH 10/13] powerpc: Add arch/powerpc mv64x60 PCI setup Mark A. Greer
2007-04-26 0:25 ` Arnd Bergmann
2007-04-26 6:33 ` Dale Farnsworth
2007-04-26 11:39 ` Arnd Bergmann
2007-04-26 14:42 ` Dale Farnsworth
2007-05-02 21:46 ` Dale Farnsworth
2007-05-03 2:13 ` Stephen Rothwell
2007-05-03 2:57 ` Dale Farnsworth
2007-05-03 7:17 ` Arnd Bergmann
2007-05-03 13:45 ` Dale Farnsworth
2007-05-04 21:10 ` [PATCH 10/13] powerpc: Add Marvell mv64x60 PCI bridge support Dale Farnsworth
2007-05-05 12:30 ` Arnd Bergmann
2007-04-26 0:01 ` [PATCH 11/13] powerpc: Add DTS file for the Motorola PrPMC2800 platform Mark A. Greer
2007-04-26 16:42 ` Scott Wood
2007-04-26 23:34 ` Mark A. Greer
2007-04-26 23:37 ` David Gibson
2007-04-27 20:41 ` Mark A. Greer
2007-04-30 16:45 ` Jon Loeliger
2007-04-30 18:08 ` Mark A. Greer
2007-04-30 22:29 ` Mark A. Greer
2007-04-26 0:02 ` [PATCH 12/13] powerpc: Add bootwrapper support for " Mark A. Greer
2007-04-26 0:02 ` [PATCH 13/13] powerpc: Add arch/powerpc support for the " Mark A. Greer
2007-04-26 0:45 ` [PATCH 0/13] powerpc: Add support for Marvell/mv64x60 and prpmc2800 David Gibson
2007-04-26 0:58 ` Mark A. Greer
2007-04-26 1:15 ` Mark A. Greer
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20070426060855.GD2030@xyzzy.farnsworth.org \
--to=dale@farnsworth.org \
--cc=arnd@arndb.de \
--cc=linuxppc-dev@ozlabs.org \
--cc=paulus@samba.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.