Re: [patch 3/4] 4xx: Convert Walnut flash mappings to new binding

[David Gibson <dwg@au1.ibm.com>]

On Sat, Sep 15, 2007 at 05:09:01PM +0200, Wolfgang Denk wrote:
> In message <1189866379.17593.2.camel@localhost.localdomain> Josh Boyer wrote:
> > On Sat, 2007-09-15 at 05:23 +0200, Stefan Roese wrote:
> ...
> > > There are not only Bamboo board running PIBS, but running U-Boot too. How 
> > > should we handle this different FLASH partitioning? Same goes for Ebony too 
> > > btw.
> > 
> > That's a good question.  I'm working on making the NOR flash show up for
> > Bamboo right now, and I had intended to just leave the partition
> > subnodes missing.
> 
> Maybe we can have  U-Boot  add  the  partition  information  if  it's
> missing in the device tree, and extend the mtdparts command in U-Boot
> to add / adjust settings so they match what is defined in U-Boot.
> 
> Stefan, what do you think?

If U-Boot is supplying a device tree, it should certainly make the
partition information match its own idea of the partitions.

For older non-device-tree away u-boot, I guess we'll have to make the
cuboot and treeboot wrappers mangle the device tree differently to
correct the partition information.

I suspect the easiest way to do this will be for the dts to contain
both treeboot and u-boot partition info, and have the wrapper delete
or nop the nodes for the other firmware.

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson