[PATCH 1/15] ide: check rq->cmd_type in drive_cmd_intr()

[Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>]

drive_cmd_intr() is used by both REQ_TYPE_ATA_CMD and REQ_TYPE_ATA_TASK
but commands using PIO-in protocol are valid only for REQ_TYPE_ATA_CMD
(&args[4] in case of REQ_TYPE_ATA_TASK points to a value for IDE_LCYL_REG
register instead of the data buffer).  This fix allows REQ_TYPE_ATA_TASK
commands to use non-zero values for IDE_SECTOR_REG (args[3]).

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
---
 drivers/ide/ide-io.c |    3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

Index: b/drivers/ide/ide-io.c
===================================================================
--- a/drivers/ide/ide-io.c
+++ b/drivers/ide/ide-io.c
@@ -659,7 +659,8 @@ static ide_startstop_t drive_cmd_intr (i
 	int retries = 10;
 
 	local_irq_enable_in_hardirq();
-	if ((stat & DRQ_STAT) && args && args[3]) {
+	if (rq->cmd_type == REQ_TYPE_ATA_CMD &&
+	    (stat & DRQ_STAT) && args && args[3]) {
 		u8 io_32bit = drive->io_32bit;
 		drive->io_32bit = 0;
 		hwif->ata_input_data(drive, &args[4], args[3] * SECTOR_WORDS);