Re: [PATCH 00/17] MMC: OMAP: Add MMC multislot support

[Tony Lindgren <tony@atomide.com>]

Hi,

* Carlos Aguiar <carlos.aguiar@indt.org.br> [071126 08:03]:
> Hi Tony and folks,
> 
> This is the latest 'MMC: OMAP: Add MMC multislot support' patch series
> with changes, corrections and improvements based on recent comments and
> suggestions from community and coworkers.
> 
> Just to remind you, this patch series adds the MMC multislot support for
> N800 and TI OMAP H2 and H3 boards, and Siemens SX1. It's based on Juha's and Jarkko's
> earlier implementation and it can be applied against most updated
> linux-omap tree (2.6.24-rc3-omap1, on top of commit 3e1251dd443d07f5a5298646adf746e4add89cf3).
>
> After recent merging of linux omap tree with linus tree, such support was broken for N800.
> After investigating it, I realize the source of the problem comes from DMA, from a line of 
> Anand Gadiyar' earlier patch committed [1].
>
> In order this support work properly on N800, please apply the patch I proposed at [2].

Thanks, pushed your DMA fix.

> I've tested with MMC, SD and SDHC cards and looks fine for the boards
> mentioned above (SX1 is compiled test only).
> 
> Testing, comments and suggestions are welcome.

Well, I've pushed most of your patches. I ended up splitting your
patch 02/17 into something that's easier to read and also compiles.
Basically I temporarily removed all the cover switch handling and
fixed the header.

I did not push patches 15-17 as the power up should be done the same
way as for other boards. Can you please refresh those patches?

Regards,

Tony