Re: [PATCH 24/24] powerpc: Base support for 440SPe "Katmai" eval board

[Stefan Roese <sr@denx.de>]

On Sunday 02 December 2007, Stefan Roese wrote:
> > +		PCIE0: pciex@d00000000 {
> > +			device_type = "pci";
> > +			#interrupt-cells = <1>;
> > +			#size-cells = <2>;
> > +			#address-cells = <3>;
> > +			compatible = "ibm,plb-pciex-440speB", "ibm,plb-pciex";
> > +			primary;
> > +			port = <0>; /* port number */
>
> port = <1>;

Ups, sorry. <0> is correct here of course. "PCIE1" and "PCIE2" need different 
numbers though.

> > +			reg = <d 00000000 20000000	/* Config space access */
> > +			       c 10000000 00001000>;	/* Registers */
> > +			dcr-reg = <100 020>;
> > +			sdr-base = <300>;
> > +
> > +			/* Outbound ranges, one memory and one IO,
> > +			 * later cannot be changed
> > +			 */
> > +			ranges = <02000000 0 80000000 0000000e 00000000 0 80000000
> > +				  01000000 0 00000000 0000000f 80000000 0 00010000>;
> > +
> > +			/* Inbound 2GB range starting at 0 */
> > +			dma-ranges = <42000000 0 0 0 0 0 80000000>;
> > +
> > +			/* This drives busses 10 to 0x1f */
> > +			bus-range = <10 1f>;
> > +
> > +			/* Legacy interrupts (note the weird polarity). We are
> > +			 * de-swizzling here because the numbers are actually for
> > +			 * port of the root complex virtual P2P bridge. But I want
> > +			 * to avoid putting a node for it in the tree, so the numbers
> > +			 * below are basically de-swizzled numbers. The real slot is
> > +			 * on idsel 1, so the swizzling is new_pin = (pin % 4) + 1
> > +			 */
> > +			interrupt-map-mask = <0000 0 0 7>;
> > +			interrupt-map = <
> > +				0000 0 0 2 &UIC3 0 4 /* swizzled int A */
> > +				0000 0 0 3 &UIC3 1 4 /* swizzled int B */
> > +				0000 0 0 4 &UIC3 2 4 /* swizzled int C */
> > +				0000 0 0 1 &UIC3 3 4 /* swizzled int D */>;
> > +		};
> > +
> > +		PCIE1: pciex@d20000000 {
> > +			device_type = "pci";
> > +			#interrupt-cells = <1>;
> > +			#size-cells = <2>;
> > +			#address-cells = <3>;
> > +			compatible = "ibm,plb-pciex-440speB", "ibm,plb-pciex";
> > +			primary;
> > +			port = <0>; /* port number */
>
> port = <2>;

That should be <1> now. And PCIE2 has this problem too.

Best regards,
Stefan