[U-Boot-Users] PPC440EPx: Make Sequoia boot vxWorks

[Stefan Roese <sr@denx.de>]

On Monday 03 December 2007, Niklaus Giger wrote:
> vxWorks expects in
> TLB 0 a entry for the Machine Check interrupt
> TLB 1 a entry for the RAM
> TLB 2 a entry for the EBC
> TLB 3 a entry for the boot flash
> Therefore I reordered the TLB entries correspondingly and did set the
> CFG_TLB_FOR_BOOT_FLASH  to 3 (see my previous patch about minimal
> support for vxWorks)
>
> After changing the baudrate to 9600 I had no problems to boot the
> vxWorks image as distributed by WindRiver (Revision 2.0/1 from
> June 18, 2007)
>
> If Stefan agrees with this patch, I will submit a similar for the yosemite
> board.

Please move such remarks that should not be added to the git commit log below 
the "---" further down. They will not be added to the git log this way.

> Signed-off-by: Niklaus Giger <niklaus.giger@netstal.com>
> ---

Here is the correct place for such remarks.

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================