[U-Boot-Users] Pull request: u-boot-ixp

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 11:56 Wed 09 Jan     , Wolfgang Denk wrote:
> Dear Jean-Christophe,
> 
> in message <20080108212200.GD674@game.jcrosoft.org> you wrote:
> > 
> > The following changes since commit 74ac5facb988fc488a707db228b177ead63a6541:
> >   Wolfgang Denk (1):
> >         Merge branch 'inka4x0-ng' of /home/m8/git/u-boot/
> > 
> > are available in the git repository at:
> > 
> >   git://denx.de/git/u-boot-ixp.git master
> 
> Sorry, but I just had to reject some of the patches you merged.
> 
> I apologize for not catching this earlier.
> 
> 
> > Jean-Christophe PLAGNIOL-VILLARD (4):
> >       Add missing file in gitignore and comments
> >       IXP: Add full baud-rate support for ixp42x, ixp45x and ixp46x
> >       ARM: support board-specific ethernet PHY init
> >       Allow CONFIG_AUTO_COMPLETE and command history CONFIG_CMDLINE_EDITING at the sametime
> 
> I merged those.
> 
> > Michael Schwingen (1):
> >       PATCH: load ixp42x NPE firmware from separate flash block, remove dead code
> 
> This was the one I skipped, as it *adds* dead  code  (in  "#if  0"  /
> "#endif" constructs) instead of removing it as the subject promises.

I will fix this and add an other patch to allow to load the NPE firmware
from flash and ram

Best Regards,
J.