[U-Boot-Users] NAND driver updates

[Stefan Roese <sr@denx.de>]

Hi Matthias,

On Thursday 10 January 2008, Matthias Fuchs wrote:
> I tested your updated NAND repo on a PLU405 board (405EP with small block
> NAND attached to EBC+GPIOs).
>
> I found two more issues and incompatibilities against the current mainline
> code:
>
> 1) The new code is much more noisy during startup:
> Old:
> ...
> DRAM:  32 MB
> FLASH:  1 MB
> NAND:  32 MiB
> PCI:   Bus Dev VenId DevId Class Int
> ...
>
> New:
> ...
> FLASH:  1 MB
> NAND:  NAND device: Manufacturer ID: 0xec, Chip ID: 0x75 (Samsung NAND
> 32MiB 3,3V 8-bit) Scanning device for bad blocks
> Bad eraseblock 261 at 0x00414000
> Bad eraseblock 352 at 0x00580000
> Bad eraseblock 846 at 0x00d38000
> Bad eraseblock 848 at 0x00d40000
> 32 MiB
> PCI:   Bus Dev VenId DevId Class Int
> ...
>
> Perhaps we should calme is down by using the option 'CFG_NAND_QUIET_TEST'.
> Also the formatting of the output is not very pretty.

Yes, we should remove those lines. I suggest to use debug() for here, so that 
they are printed when DEBUG is defined.

> 2) 'nand read.jffs2' and 'nand read.i' do not read anything.
> 'nand read' is ok. Are there any boards where you tested this ok?

No, I didn't test this. IIRC there is still a TODO in the source that this 
still has to be implemented/tested. It shouldn't be that hard though. I would 
really appreciate it if you (or somebody else) could take a look at this.

Thanks.

BTW: I'm not available today.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================