Re: ath5k: reset for 5424-based card

[Bob Copeland <me@bobcopeland.com>]

On Sat, Feb 02, 2008 at 03:48:34AM +0200, Nick Kossifidis wrote:
> > Yeah I have an AP but it's broadcom based.  I'll try to do the traces this
> > weekend.
> >
> 
> Thanx ;-)

Ok, so I did -b and -g traces.  That branch is a little out of date, so 
I wound up downgrading to 2.6.22.

I don't have an a-capable AP, so how might I get a/turboa/turbog traces?
Do I use wlanconfig from the madwifi docs like so:

   $ iwpriv ath0 mode 1
   $ wlanconfig ath0 create wlandev wifi0 wlanmode ap

What mode # is used for turbo a/g?

I put the tarballs at http://bobcopeland.com/ath5k/

> Great info ! Your card sends the RXORN interrupt (Rx overrun), at
> least we know what the problem is ;-)
> 
> How about your signal strength ?

Looks fine, I think:
    Quality=89/100  Signal level=-39 dBm  Noise level=-96 dBm

> That's ok since we haven't added initvals/rfbuffer tables for your
> card so phy isn't initialized propertly (this is the first problem we
> should fix so we can be sure that rx overrun is not phy-related).

OK, well I guess that info is in the tarballs.  I poked around in the
code, and it looks like my tables are similar to 5413 with maybe a 
couple of extra registers.  But I'll await your analysis. :)

> 1472         if (ah->ah_version != AR5K_AR5210) {
> 1473                 /*HIU = Host Interface Unit (PCI etc)*/
> 1474                 if (unlikely(data & (AR5K_ISR_HIUERR)))
> 1475                         *interrupt_mask |= AR5K_INT_FATAL;
> 
> 
> Change AR5K_ISR_HIUERR with AR5K_ISR_RXORN

It does get rid of the message, but other than not seeing the printk
any more, it doesn't seem to help things much. 
 
Good luck on the exams! 

-- 
Bob Copeland %% www.bobcopeland.com