All of lore.kernel.org
 help / color / mirror / Atom feed
From: Peter Meszmer <hubblest@web.de>
To: Matthias Schwarzott <zzam@gentoo.org>
Cc: linux-dvb@linuxtv.org
Subject: Re: [linux-dvb] AVerMedia DVB-S Hybrid+FM and DVB-S Pro [A700]
Date: Wed, 13 Feb 2008 11:05:49 +0100	[thread overview]
Message-ID: <200802131105.49910.hubblest@web.de> (raw)
In-Reply-To: <200802122206.30369.zzam@gentoo.org>

Am Dienstag, 12. Februar 2008 schrieben Sie:
> I added this to the wiki-page about A700:
> http://www.linuxtv.org/wiki/index.php/AVerMedia_AVerTV_DVB-S_Pro_(A700)
>
> Maybe we should rename the page to AverMedia_AverTV_DVB-S_A700 or anything
> similar.
>
> * Could you load saa7134 module of unpatched driver, but with parameter
> i2c_scan=1.
> * lspci -vvnn also should be interesting
> * If you have a camera, could you do a picture, so we can get info about
> the used analog tuner. I guess it is some XC30??. But to get it running you
> should contact video4linux mailinglist.
>
>
> Regards
> Matthias


Hello Matthias,

if I load the saa7134 module of unpatched driver, but with parameter 
i2c_scan=1, dmesg shows (Kernel 2.6.24-gentoo-r2)

saa7130/34: v4l2 driver version 0.2.14 loaded
saa7133[0]: found at 0000:02:07.0, rev: 209, irq: 18, latency: 64, mmio: 
0xd3024000
saa7133[0]: subsystem: 1461:a7a2, board: UNKNOWN/GENERIC [card=0,autodetected]
saa7133[0]: board init: gpio is 6da00
saa7133[0]: i2c eeprom 00: 61 14 a2 a7 ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c scan: found device @ 0x1c  [???]
saa7133[0]: i2c scan: found device @ 0xa0  [eeprom]
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0

and lspci -vvnn returns

02:07.0 Multimedia controller [0480]: Philips Semiconductors SAA7133/SAA7135 
Video Broadcast Decoder [1131:7133] (rev d1)
        Subsystem: Avermedia Technologies Inc Unknown device [1461:a7a2]
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 64 (63750ns min, 63750ns max)
        Interrupt: pin A Route to IRQ 18
        Region 0: Memory at d3024000 (32-bit, non-prefetchable) [size=2K]
        Capabilities: [40] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=3 PME-
        Kernel driver in use: saa7134
        Kernel modules: saa7134

I did some pictures too... the link to them is in a PM for you. The analog 
tuner seems to be a XC2028, but I don't see any possibilities to test the 
tuner.

Regards
Peter

_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

  reply	other threads:[~2008-02-13 10:11 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2008-02-07 15:23 [linux-dvb] AVerMedia DVB-S Hybrid+FM and DVB-S Pro [A700] Eduard Huguet
2008-02-07 16:47 ` Peter Meszmer
2008-02-07 19:13 ` Matthias Schwarzott
2008-02-07 20:12   ` Eduard Huguet
2008-02-07 21:19   ` Peter Meszmer
2008-02-12 21:06     ` Matthias Schwarzott
2008-02-13 10:05       ` Peter Meszmer [this message]
2008-02-13 12:59         ` Matthias Schwarzott
  -- strict thread matches above, loose matches on Subject: below --
2008-02-07  9:23 Peter Meszmer
2008-02-13 18:17 ` Matthias Schwarzott

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=200802131105.49910.hubblest@web.de \
    --to=hubblest@web.de \
    --cc=linux-dvb@linuxtv.org \
    --cc=zzam@gentoo.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.