From: Sam Ravnborg <sam@ravnborg.org>
To: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>,
Sergei Shtylyov <sshtylyov@ru.mvista.com>,
LKML <linux-kernel@vger.kernel.org>,
linux-ide@vger.kernel.org
Subject: [PATCH] hpt366: fix section mismatch warnings
Date: Fri, 22 Feb 2008 20:46:51 +0100 [thread overview]
Message-ID: <20080222194651.GA7154@uranus.ravnborg.org> (raw)
hpt366: fix section mismatch warnings
Fix following warnings:
WARNING: o-sparc64/vmlinux.o(.data+0x195a38): Section mismatch in reference from the variable hpt37x_info.0 to the variable .devinit.data:hpt370
WARNING: o-sparc64/vmlinux.o(.data+0x195a40): Section mismatch in reference from the variable hpt37x_info.0 to the variable .devinit.data:hpt370a
WARNING: o-sparc64/vmlinux.o(.data+0x195a48): Section mismatch in reference from the variable hpt37x_info.0 to the variable .devinit.data:hpt372
WARNING: o-sparc64/vmlinux.o(.data+0x195a50): Section mismatch in reference from the variable hpt37x_info.0 to the variable .devinit.data:hpt372n
Replace a static array with a small switch resulting in
more readable code.
Be consistent in use of __devinitconst for const data
to avoid section type conflicts.
Mark the pci table __devinitconst.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Cc: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
---
Only build tested but looks obviously correct.
I saw this doing a sparc64 build - dunno whit it did not
surface when I sweeped over an x86 64 bit allyesconfig.
Sam
diff --git a/drivers/ide/pci/hpt366.c b/drivers/ide/pci/hpt366.c
index d0f7bb8..9911584 100644
--- a/drivers/ide/pci/hpt366.c
+++ b/drivers/ide/pci/hpt366.c
@@ -513,7 +513,7 @@ static struct hpt_timings hpt37x_timings = {
}
};
-static const struct hpt_info hpt36x __devinitdata = {
+static const struct hpt_info hpt36x __devinitconst = {
.chip_name = "HPT36x",
.chip_type = HPT36x,
.udma_mask = HPT366_ALLOW_ATA66_3 ? (HPT366_ALLOW_ATA66_4 ? ATA_UDMA4 : ATA_UDMA3) : ATA_UDMA2,
@@ -521,7 +521,7 @@ static const struct hpt_info hpt36x __devinitdata = {
.timings = &hpt36x_timings
};
-static const struct hpt_info hpt370 __devinitdata = {
+static const struct hpt_info hpt370 __devinitconst = {
.chip_name = "HPT370",
.chip_type = HPT370,
.udma_mask = HPT370_ALLOW_ATA100_5 ? ATA_UDMA5 : ATA_UDMA4,
@@ -529,7 +529,7 @@ static const struct hpt_info hpt370 __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt370a __devinitdata = {
+static const struct hpt_info hpt370a __devinitconst = {
.chip_name = "HPT370A",
.chip_type = HPT370A,
.udma_mask = HPT370_ALLOW_ATA100_5 ? ATA_UDMA5 : ATA_UDMA4,
@@ -537,7 +537,7 @@ static const struct hpt_info hpt370a __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt374 __devinitdata = {
+static const struct hpt_info hpt374 __devinitconst = {
.chip_name = "HPT374",
.chip_type = HPT374,
.udma_mask = ATA_UDMA5,
@@ -545,7 +545,7 @@ static const struct hpt_info hpt374 __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt372 __devinitdata = {
+static const struct hpt_info hpt372 __devinitconst = {
.chip_name = "HPT372",
.chip_type = HPT372,
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -553,7 +553,7 @@ static const struct hpt_info hpt372 __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt372a __devinitdata = {
+static const struct hpt_info hpt372a __devinitconst = {
.chip_name = "HPT372A",
.chip_type = HPT372A,
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -561,7 +561,7 @@ static const struct hpt_info hpt372a __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt302 __devinitdata = {
+static const struct hpt_info hpt302 __devinitconst = {
.chip_name = "HPT302",
.chip_type = HPT302,
.udma_mask = HPT302_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -569,7 +569,7 @@ static const struct hpt_info hpt302 __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt371 __devinitdata = {
+static const struct hpt_info hpt371 __devinitconst = {
.chip_name = "HPT371",
.chip_type = HPT371,
.udma_mask = HPT371_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -577,7 +577,7 @@ static const struct hpt_info hpt371 __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt372n __devinitdata = {
+static const struct hpt_info hpt372n __devinitconst = {
.chip_name = "HPT372N",
.chip_type = HPT372N,
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -585,7 +585,7 @@ static const struct hpt_info hpt372n __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt302n __devinitdata = {
+static const struct hpt_info hpt302n __devinitconst = {
.chip_name = "HPT302N",
.chip_type = HPT302N,
.udma_mask = HPT302_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -593,7 +593,7 @@ static const struct hpt_info hpt302n __devinitdata = {
.timings = &hpt37x_timings
};
-static const struct hpt_info hpt371n __devinitdata = {
+static const struct hpt_info hpt371n __devinitconst = {
.chip_name = "HPT371N",
.chip_type = HPT371N,
.udma_mask = HPT371_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
@@ -1475,7 +1475,7 @@ static int __devinit hpt36x_init(struct pci_dev *dev, struct pci_dev *dev2)
IDE_HFLAG_ABUSE_SET_DMA_MODE | \
IDE_HFLAG_OFF_BOARD)
-static const struct ide_port_info hpt366_chipsets[] __devinitdata = {
+static const struct ide_port_info hpt366_chipsets[] __devinitconst = {
{ /* 0 */
.name = "HPT36x",
.init_chipset = init_chipset_hpt366,
@@ -1570,11 +1570,13 @@ static int __devinit hpt366_init_one(struct pci_dev *dev, const struct pci_devic
if (rev < 3)
info = &hpt36x;
else {
- static const struct hpt_info *hpt37x_info[] =
- { &hpt370, &hpt370a, &hpt372, &hpt372n };
-
- info = hpt37x_info[min_t(u8, rev, 6) - 3];
- idx++;
+ switch (min_t(u8, rev, 6) - 3) {
+ case 0: info = &hpt370; break;
+ case 1: info = &hpt370a; break;
+ case 2: info = &hpt372; break;
+ case 3: info = &hpt372n; break;
+ }
+ idx++;
}
break;
case 1:
@@ -1626,7 +1628,7 @@ static int __devinit hpt366_init_one(struct pci_dev *dev, const struct pci_devic
return ide_setup_pci_device(dev, &d);
}
-static const struct pci_device_id hpt366_pci_tbl[] = {
+static const struct pci_device_id hpt366_pci_tbl[] __devinitconst = {
{ PCI_VDEVICE(TTI, PCI_DEVICE_ID_TTI_HPT366), 0 },
{ PCI_VDEVICE(TTI, PCI_DEVICE_ID_TTI_HPT372), 1 },
{ PCI_VDEVICE(TTI, PCI_DEVICE_ID_TTI_HPT302), 2 },
next reply other threads:[~2008-02-22 19:46 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-02-22 19:46 Sam Ravnborg [this message]
2008-02-22 19:53 ` [PATCH] hpt366: fix section mismatch warnings Sergei Shtylyov
2008-02-22 20:57 ` Bartlomiej Zolnierkiewicz
2008-02-22 20:43 ` Sam Ravnborg
2008-02-23 21:22 ` [Fixed PATCH] " Sam Ravnborg
2008-02-24 14:33 ` Bartlomiej Zolnierkiewicz
2008-02-24 17:53 ` Sam Ravnborg
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080222194651.GA7154@uranus.ravnborg.org \
--to=sam@ravnborg.org \
--cc=bzolnier@gmail.com \
--cc=linux-ide@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=sshtylyov@ru.mvista.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.