[U-Boot-Users] [PATCH 3/3] QE IO - Add pario command

[Wolfgang Denk <wd@denx.de>]

In message <47F11124.8070705@freescale.com> you wrote:
> 
> > As far as I managed to understand, reginfo just shows a dump of CPU
> > based register values, while pario allows you to set and get the value
> > of a GPIO port - two different things. We found this very useful for
> > debugging our board, and I think it can be useful for many other
> > processor families as well. 
> 
> There is also a "qe" command that takes sub-commands as a parameter.  Currently,
> the only one is "qe fw" for uploading firmware.  Perhaps you could do "qe pario"?

Please don;t.

Instead of adding such functionality several times in several  places
distributed all over the whole source tree, let's do it just once and
right.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Even historians fail to learn from history -- they repeat the same
mistakes.
	-- John Gill, "Patterns of Force", stardate 2534.7