From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bartlomiej Zolnierkiewicz Subject: [PATCH 3/3] siimage: remove proc_reports_siimage() Date: Wed, 9 Apr 2008 20:52:41 +0200 Message-ID: <200804092052.41806.bzolnier@gmail.com> Mime-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Return-path: Received: from nf-out-0910.google.com ([64.233.182.191]:55005 "EHLO nf-out-0910.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753659AbYDISic (ORCPT ); Wed, 9 Apr 2008 14:38:32 -0400 Received: by nf-out-0910.google.com with SMTP id g13so1239007nfb.21 for ; Wed, 09 Apr 2008 11:38:31 -0700 (PDT) Content-Disposition: inline Sender: linux-ide-owner@vger.kernel.org List-Id: linux-ide@vger.kernel.org To: linux-ide@vger.kernel.org Cc: linux-kernel@vger.kernel.org * proc_reports_siimage() is now only called by init_chipset_siimage() so inline it there. * Use array instead of switch statement for reporting clock modes. There should be no functional changes caused by this patch. Signed-off-by: Bartlomiej Zolnierkiewicz --- drivers/ide/pci/siimage.c | 33 ++++++++------------------------- 1 file changed, 8 insertions(+), 25 deletions(-) Index: b/drivers/ide/pci/siimage.c =================================================================== --- a/drivers/ide/pci/siimage.c +++ b/drivers/ide/pci/siimage.c @@ -440,30 +440,6 @@ static void sil_sata_pre_reset(ide_drive } /** - * proc_reports_siimage - add siimage controller to proc - * @dev: PCI device - * @clocking: SCSC value - * @name: controller name - * - * Report the clocking mode of the controller and add it to - * the /proc interface layer - */ - -static void proc_reports_siimage (struct pci_dev *dev, u8 clocking, const char *name) -{ - if (!pdev_is_sata(dev)) { - printk(KERN_INFO "%s: BASE CLOCK ", name); - clocking &= 0x03; - switch (clocking) { - case 0x03: printk("DISABLED!\n"); break; - case 0x02: printk("== 2X PCI\n"); break; - case 0x01: printk("== 133\n"); break; - case 0x00: printk("== 100\n"); break; - } - } -} - -/** * setup_mmio_siimage - switch an SI controller into MMIO * @dev: PCI device we are configuring * @name: device name @@ -585,7 +561,14 @@ static unsigned int __devinit init_chips writel(0x00680000, ioaddr + 0x1C8); } - proc_reports_siimage(dev, tmp >> 4, name); + /* report the clocking mode of the controller */ + if (!pdev_is_sata(dev)) { + static const char *clk_str[] = + { "== 100", "== 133", "== 2X PCI", "DISABLED!" }; + + tmp >>= 4; + printk(KERN_INFO "%s: BASE CLOCK %s\n", name, clk_str[tmp & 3]); + } return 0; }