From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Tue, 10 Jun 2008 17:34:28 +0200
Subject: [U-Boot-Users]
	=?iso-8859-1?q?=5BPATCH_1/4=5D_Change_initdram=28?=
	=?iso-8859-1?q?=29_return_type_to=09phys=5Fsize=5Ft?=
In-Reply-To: <1213111831.16606.2.camel@ld0161-tx32>
References: <1213061838-12493-1-git-send-email-becky.bruce@freescale.com>
	<1213111831.16606.2.camel@ld0161-tx32>
Message-ID: <200806101734.28371.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Tuesday 10 June 2008, Jon Loeliger wrote:
> On Mon, 2008-06-09 at 20:37 -0500, Becky Bruce wrote:
> > This patch changes the return type of initdram() from long int to
> > phys_size_t. This is required for a couple of reasons: long int limits
> > the amount of dram to 2GB, and u-boot in general is moving over to
> > phys_size_t to represent the size of physical memory.  phys_size_t is
> > defined as an unsigned long on almost all current platforms.
> >
> > This patch *only* changes the return type of the initdram function (in
> > include/common.h, as well as in each board's implementation of initdram).
> >  It does not actually modify the code inside the function on any of the
> > platforms; platforms which wish to support more than 2GB of DRAM will
> > need to modify their initdram() function code.
> >
> > Build tested with MAKEALL for ppc, arm, mips, mips-el. Booted on powerpc
> > MPC8641HPCN.
> >
> > Patch is too large for the list, and is located at:
> > http://gate.crashing.org/~galak/0001-Change-initdram-return-type-to-phys_
> >size_t.patch
>
> The whole 4-part series:
>
> Acked-by: Jon Loeliger <jdl@freescale.com>

Acked-by: Stefan Roese <sr@denx.de>

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================