All of lore.kernel.org
 help / color / mirror / Atom feed
From: Ales Jurik <ajurik@quick.cz>
To: linux-dvb@linuxtv.org
Subject: Re: [linux-dvb] Re : Re : No lock possible at some DVB-S2 channels with TT S2-3200/linux
Date: Sat, 21 Jun 2008 15:52:41 +0200	[thread overview]
Message-ID: <200806211552.41278.ajurik@quick.cz> (raw)
In-Reply-To: <200806211436.47765.dkuhlen@gmx.net>

Hi,

on the frequency you've mentioned I didn't have any problem (never). But at 
lyngsat it is reported as 11914MHz. I never used freq. shifting (only 
tested), it was not reasonable for me.

Problems I have are at transponders with 8PSK modulation. 

Thanks and Best Regards,

Ales


On Saturday 21 of June 2008, Dominik Kuhlen wrote:
> Hi
>
> ------snip----
>
> > > Could you please try the attached patch if this fixes the problem with
> > > nominal frequency/symbolrate settings?
> >
> > Many thanks, but I don't see any improvement. Minimum time after I've
> > lock is 150s.
>
> Could you please check whether the reported frequency is sane:
> Example: 19.2°E 11915MHz H 27500 DVB-S2
>
> Test1: use the nominal frequency:
>  ./simpledvbtune -f 11915 -d 2
> dvbfe setparams :  delsys=4 1315.000MHz / Rate : 27500kSPS
> Status: 1b: Signal Carrier Sync Lock
> SNR: 0 44 (0x2c) (4.4dB)
> BER: 0 0 0 0 (0x0)
> Signal: 5 170 (0x5aa) 1450 (145.0dBm)
> Frontend: if=1313.627 MHz
>
> Test2: set positive offset (+3MHz):
> ./simpledvbtune -f 11918 -d 2
> dvbfe setparams :  delsys=4 1318.000MHz / Rate : 27500kSPS
> Frontend: if=1313.660 MHz
> The frontend does automatically locks on the correct frequency
>
> Test3: set negative offset (-4MHz):
> ./simpledvbtune -f 11911 -d 2
> dvbfe setparams :  delsys=4 1311.000MHz / Rate : 27500kSPS
> Frontend: if=1313.650 MHz
>
> Find lower limit:
> ./simpledvbtune -f 11896 -d 2  (does not work)
> ./simpledvbtune -f 11897 -d 2 (works 100%)
> dvbfe setparams :  delsys=4 1297.000MHz / Rate : 27500kSPS
> Frontend: if=1313.654 MHz
>
> Find upper limit:
> ./simpledvbtune -f 11930 -d 2 (does not work)
> ./simpledvbtune -f 11929 -d 2 (works 100%)
> dvbfe setparams :  delsys=4 1329.000MHz / Rate : 27500kSPS
> Frontend: if=1313.645 MHz
>
> Which means:
>  - I can specify any frequency from 11896MHz to 11929MHz and get 100% lock
> success - and the Frontend (actually the derotator) reports the real
> frequency (e.g. for auto correcting the channels list)
>
> Cards I have tested so far:
> - pctv452e
> - mantis (Multimedia controller [0480]: Twinhan Technology Co. Ltd Mantis
> DTV PCI Bridge Controller [Ver 1.0] [1822:4e35] (rev 01) Subsystem: Twinhan
> Technology Co. Ltd Unknown device [1822:0031])
>
> Unfortunately I'm trapped behind a single-cable installation and have only
> access to 19.2°E Highband Horizontal
>
>
> Dominik



_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

  reply	other threads:[~2008-06-21 13:53 UTC|newest]

Thread overview: 25+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2008-05-12 18:42 [linux-dvb] No lock possible at some DVB-S2 channels with TT S2-3200/linux Ales Jurik
2008-05-13 17:58 ` [linux-dvb] Re : " manu
2008-05-13 21:26   ` Ales Jurik
2008-05-13 22:01     ` [linux-dvb] Re : " manu
2008-05-22  8:13       ` Ales Jurik
2008-05-22  9:34         ` [linux-dvb] Re : Re : No lock possible at some DVB-S2 channelswith " Igor
2008-06-15  9:47         ` [linux-dvb] Re : Re : No lock possible at some DVB-S2 channels with " Dominik Kuhlen
2008-06-15 17:20           ` Ales Jurik
2008-06-16  2:21             ` [linux-dvb] Re : " manu
2008-06-16  8:20               ` Ales Jurik
2008-06-16 19:14                 ` joep
2008-06-16 20:26                   ` ChaosMedia > WebDev
2008-06-16 20:45                   ` Ales Jurik
2008-06-20 13:18                     ` Daniel
2008-06-20 13:47                       ` Ales Jurik
2008-06-20 14:33                         ` Daniel
2008-06-20 15:32                           ` psofa
2008-06-20 15:45                         ` joep
2008-06-21 12:36             ` [linux-dvb] " Dominik Kuhlen
2008-06-21 13:52               ` Ales Jurik [this message]
2008-06-21 16:40                 ` Dominik Kuhlen
2008-06-21 17:20                   ` Ales Jurik
2008-06-22 18:19                     ` psofa
2008-06-26 19:58                     ` Goga777
  -- strict thread matches above, loose matches on Subject: below --
2008-06-15 19:31 psofa

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=200806211552.41278.ajurik@quick.cz \
    --to=ajurik@quick.cz \
    --cc=linux-dvb@linuxtv.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.