Re: [PATCH v2] OMAP3: Update USBHOST pinmux settings

[David Brownell <david-b@pacbell.net>]

On Tuesday 30 September 2008, Gadiyar, Anand wrote:
> From: Anand Gadiyar <gadiyar@ti.com>
> 
> Add pin-mux settings for OHCI in PHY mode.
> Also change settings for EHCI in TLL mode.
> 
> Signed-off-by: Anand Gadiyar <gadiyar@ti.com>
> ---
> Fixed comments below. Also fixed one pin that should
> have been marked output, but was wrongly marked input.
> 
>  arch/arm/mach-omap2/mux.c             |   67 +++++++++++++++++++++++++++-------
>  arch/arm/plat-omap/include/mach/mux.h |   26 ++++++++++++-
>  2 files changed, 80 insertions(+), 13 deletions(-)

I didn't see anything obvious to complain about, but then I've
not delved deeply into OMAP3 EHCI.

Were you the person who was looking to package the PHY/TLL
mode setup in platform data?  Any progress on that?

(I added EHCI to my Beagle/Overo config, and it came up
with all kinds of nonsense on the Beagle.  Configured
several ports, not just one, and in fact this board does
not even *have* the EHCI transceiver.  So it was very
obvious that EHCI setup wasn't right yet.  That's even
apart from the messaging goofs, which have trivial fixes
I'll send along in a while.)

- dave

--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html