Re: [PATCH] bonding: send IPv6 neighbor advertisement on failover

[Simon Horman <horms@verge.net.au>]

On Tue, Oct 07, 2008 at 09:13:01PM -0400, Brian Haley wrote:
> This patch adds better IPv6 failover support for bonding devices,  
> especially when in active-backup mode and there are only IPv6 addresses  
> configured, as reported by Alex Sidorenko.
>
> - Creates a new file, net/drivers/bonding/bond_ipv6.c, for the
>   IPv6-specific routines.  Both regular bonds and VLANs over bonds
>   are supported.
>
> - Adds a new tunable, num_unsol_na, to limit the number of unsolicited
>   IPv6 Neighbor Advertisements that are sent on a failover event.
>   Default is 1.
>
> - Creates two new IPv6 neighbor discovery functions:
>
>   ndisc_build_skb()
>   ndisc_send_skb()
>
>   These were required to support VLANs since we have to be able to
>   add the VLAN id to the skb since ndisc_send_na() and friends
>   shouldn't be asked to do this.  These two routines are basically
>   __ndisc_send() split into two pieces, in a slightly different order.
>
> - Updates Documentation/networking/bonding.txt and bumps the rev of bond
>   support to 3.4.0.
>
> On failover, this new code will generate one packet:
>
> - An unsolicited IPv6 Neighbor Advertisement, which helps the switch
>   learn that the address has moved to the new slave.
>
> Testing has shown that sending just the NA results in pretty good  
> behavior when in active-back mode, I saw no lost ping packets for 
> example.
>
> -Brian
>
> Signed-off-by: Brian Haley <brian.haley@hp.com>

The Kconfig / build portions of this look fine to me.


-- 
Simon Horman
  VA Linux Systems Japan K.K., Sydney, Australia Satellite Office
  H: www.vergenet.net/~horms/             W: www.valinux.co.jp/en