From: Stanislaw Gruszka <stf_xl@wp.pl>
To: linux-ide@vger.kernel.org, Andrew Victor <avictor.za@gmail.com>
Cc: linux-arm-kernel@lists.arm.linux.org.uk
Subject: [PATCH 3/3 v4] AT91: initialize Compact Flash on AT91SAM9263 cpu
Date: Wed, 18 Feb 2009 11:07:26 +0100 [thread overview]
Message-ID: <200902181107.27095.stf_xl@wp.pl> (raw)
Signed-off-by: Stanislaw Gruszka <stf_xl@wp.pl>
---
arch/arm/mach-at91/at91sam9263_devices.c | 105 ++++++++++++++++++++++++++++++
1 files changed, 105 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-at91/at91sam9263_devices.c b/arch/arm/mach-at91/at91sam9263_devices.c
index b753cb8..f048043 100644
--- a/arch/arm/mach-at91/at91sam9263_devices.c
+++ b/arch/arm/mach-at91/at91sam9263_devices.c
@@ -347,6 +347,111 @@ void __init at91_add_device_mmc(short mmc_id, struct at91_mmc_data *data)
void __init at91_add_device_mmc(short mmc_id, struct at91_mmc_data *data) {}
#endif
+/* --------------------------------------------------------------------
+ * Compact Flash (PCMCIA or IDE)
+ * -------------------------------------------------------------------- */
+
+#if defined(CONFIG_AT91_CF) || defined(CONFIG_AT91_CF_MODULE) || \
+ defined(CONFIG_BLK_DEV_IDE_AT91) || defined(CONFIG_BLK_DEV_IDE_AT91_MODULE)
+
+static struct at91_cf_data cf0_data;
+
+static struct resource cf0_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_4,
+ .end = AT91_CHIPSELECT_4 + SZ_256M - 1,
+ .flags = IORESOURCE_MEM | IORESOURCE_MEM_8AND16BIT,
+ }
+};
+
+static struct platform_device cf0_device = {
+ .id = 0,
+ .dev = {
+ .platform_data = &cf0_data,
+ },
+ .resource = cf0_resources,
+ .num_resources = ARRAY_SIZE(cf0_resources),
+};
+
+static struct at91_cf_data cf1_data;
+
+static struct resource cf1_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_5,
+ .end = AT91_CHIPSELECT_5 + SZ_256M - 1,
+ .flags = IORESOURCE_MEM | IORESOURCE_MEM_8AND16BIT,
+ }
+};
+
+static struct platform_device cf1_device = {
+ .id = 1,
+ .dev = {
+ .platform_data = &cf1_data,
+ },
+ .resource = cf1_resources,
+ .num_resources = ARRAY_SIZE(cf1_resources),
+};
+
+void __init at91_add_device_cf(struct at91_cf_data *data)
+{
+ unsigned long ebi0_csa;
+ struct platform_device *pdev;
+
+ if (!data)
+ return;
+
+ /*
+ * assign CS4 or CS5 to SMC with Compact Flash logic support,
+ * we assume SMC timings are configured by board code,
+ * except True IDE where timings are controlled by driver
+ */
+ ebi0_csa = at91_sys_read(AT91_MATRIX_EBI0CSA);
+ switch (data->chipselect) {
+ case 4:
+ at91_set_A_periph(AT91_PIN_PD6, 0); /* EBI0_NCS4/CFCS0 */
+ ebi0_csa |= AT91_MATRIX_EBI0_CS4A_SMC_CF1;
+ cf0_data = *data;
+ pdev = &cf0_device;
+ break;
+ case 5:
+ at91_set_A_periph(AT91_PIN_PD7, 0); /* EBI0_NCS5/CFCS1 */
+ ebi0_csa |= AT91_MATRIX_EBI0_CS5A_SMC_CF2;
+ cf1_data = *data;
+ pdev = &cf1_device;
+ break;
+ default:
+ printk(KERN_ERR "AT91 CF: bad chip-select requested (%u)\n",
+ data->chipselect);
+ return;
+ }
+ at91_sys_write(AT91_MATRIX_EBI0CSA, ebi0_csa);
+
+ if (data->det_pin) {
+ at91_set_gpio_input(data->det_pin, 1);
+ at91_set_deglitch(data->det_pin, 1);
+ }
+
+ if (data->irq_pin) {
+ at91_set_gpio_input(data->irq_pin, 1);
+ at91_set_deglitch(data->irq_pin, 1);
+ }
+
+ if (data->vcc_pin)
+ /* initially off */
+ at91_set_gpio_output(data->vcc_pin, 0);
+
+ /* enable EBI controlled pins */
+ at91_set_A_periph(AT91_PIN_PD5, 1); /* NWAIT */
+ at91_set_A_periph(AT91_PIN_PD8, 0); /* CFCE1 */
+ at91_set_A_periph(AT91_PIN_PD9, 0); /* CFCE2 */
+ at91_set_A_periph(AT91_PIN_PD14, 0); /* CFNRW */
+
+ pdev->name = (data->flags & AT91_CF_TRUE_IDE) ? "at91_ide" : "at91_cf";
+ platform_device_register(pdev);
+}
+#else
+void __init at91_add_device_cf(struct at91_cf_data *data) {}
+#endif
/* --------------------------------------------------------------------
* NAND / SmartMedia
--
1.5.2.5
next reply other threads:[~2009-02-18 10:07 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-02-18 10:07 Stanislaw Gruszka [this message]
2009-03-01 19:11 ` [PATCH 3/3 v4] AT91: initialize Compact Flash on AT91SAM9263 cpu Sergei Shtylyov
2009-03-02 16:33 ` Bartlomiej Zolnierkiewicz
2009-03-02 19:54 ` Andrew Victor
2009-03-05 13:48 ` Bartlomiej Zolnierkiewicz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200902181107.27095.stf_xl@wp.pl \
--to=stf_xl@wp.pl \
--cc=avictor.za@gmail.com \
--cc=linux-arm-kernel@lists.arm.linux.org.uk \
--cc=linux-ide@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.