[U-Boot] [PATCH 1/1] Add config option for disabling DM9000-SROM support.

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 11:26 Sun 03 May     , Remy Bohmer wrote:
> Some boards do not have SROM support for the DM9000 network adapter.
> Instead of listing these board names in the driver code, make this
> option configurable from the board config file.
> 
> It also removes a build warning for the at91sam9261ek board:
> 'dm9000x.c:545: warning: 'read_srom_word' defined but not used'
> 
> And it repaires the trizepsiv board build which was broken around the
> same routines
please put Stelian in Cc
> 
> Signed-off-by: Remy Bohmer <linux@bohmer.net>
> ---
>  board/trizepsiv/eeprom.c        |   14 +++++++-------
>  drivers/net/dm9000x.c           |   16 ++++++++--------
>  include/configs/at91sam9261ek.h |    1 +
>  include/dm9000.h                |   11 +++++++++++
>  4 files changed, 27 insertions(+), 15 deletions(-)
>  create mode 100644 include/dm9000.h
> 
> diff --git a/board/trizepsiv/eeprom.c b/board/trizepsiv/eeprom.c
> index 63f1c6c..9fa7aef 100644
> --- a/board/trizepsiv/eeprom.c
> +++ b/board/trizepsiv/eeprom.c
> @@ -23,17 +23,17 @@
>  
>  #include <common.h>
>  #include <command.h>
> -

  
> @@ -347,9 +347,9 @@ eth_init(bd_t * bd)
>  
>  	/* Set Node address */
>  	if (!eth_getenv_enetaddr("ethaddr", enetaddr)) {
> -#if !defined(CONFIG_AT91SAM9261EK)
> +#if !defined(CONFIG_DM9000_NO_SROM_AVAIL)
CONFIG_DM9000_NO_SROM will be shorter and the same
>  		for (i = 0; i < 3; i++)
> -			read_srom_word(i, enetaddr + 2 * i);
> +			dm9000_read_srom_word(i, enetaddr + 2 * i);
>  		eth_setenv_enetaddr("ethaddr", enetaddr);
>  #endif


>  
> diff --git a/include/dm9000.h b/include/dm9000.h
> new file mode 100644
> index 0000000..d59919b
> --- /dev/null
> +++ b/include/dm9000.h
Ben what do you think to do as usb have a dir to store all net header
include/net/

> @@ -0,0 +1,11 @@
Copyrigth?
> +
> +#ifndef __DM9000_H__
> +#define __DM9000_H__

Best Regards,
J.