From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Wed, 8 Jul 2009 11:26:25 +0200
Subject: [U-Boot] [PATCH] for JEDEC flash,
	command of word programing should be issued relatvie to base
In-Reply-To: <ec1aee9f0907062227t5e904fe6rf620f6cbc57c9415@mail.gmail.com>
References: <ec1aee9f0907062227t5e904fe6rf620f6cbc57c9415@mail.gmail.com>
Message-ID: <200907081126.25171.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Tuesday 07 July 2009 07:27:35 Po-Yu Chuang wrote:
> For JEDEC flash, we should issue word programming command relative to
> base address rather than sector base address. Original source makes
> SST Flash fails to program sectors which are not on the 0x10000 boundaries.
>
> e.g.
> SST39LF040 uses addr1=0x5555 and addr2=0x2AAA, however, each sector
> is 0x1000 bytes.
>
> Thus, if we issue command to "sector base (0x41000) + offset(0x5555)",
> it sends to 0x46555 and the chip fails to recognize that address.
>
> This patch is tested with SST39LF040.
>
> Signed-off-by: Po-Yu Chuang <ratbert@faraday-tech.com>

This patch is line wrapped and can't be applied. Please fix and resubmit. And 
while at it please use a somewhat shorted subject.

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================