Re: [PATCH 10/10] OMAP3: update OMAP3 Beagle defconfig, v2

[Tony Lindgren <tony@atomide.com>]

* Felipe Balbi <me@felipebalbi.com> [090812 22:11]:
> On Wed, Aug 12, 2009 at 10:20:34AM -0700, Kevin Hilman wrote:
> > Tony Lindgren <tony@atomide.com> writes:
> > 
> > > * Felipe Balbi <felipe.balbi@nokia.com> [090812 15:29]:
> > >> Hi,
> > >> 
> > >> On Wed, Aug 12, 2009 at 02:24:15PM +0200, ext Tony Lindgren wrote:
> > >> > From: Paul Walmsley <paul@pwsan.com>
> > >> > 
> > >> > Update the OMAP3 Beagle defconfig to add EHCI, MMC, TWL4030 GPIO support.
> > >> > Beagle can again use MMC rootfs after this patch.  Tested on BeagleBoard
> > >> > rev C2.
> > >> > 
> > >
> > > <snip>
> > >
> > >> > @@ -981,10 +987,11 @@ CONFIG_RTC_INTF_DEV=y
> > >> >  #
> > >> >  # Voltage and Current regulators
> > >> >  #
> > >> > -# CONFIG_REGULATOR is not set
> > >> > +CONFIG_REGULATOR=y
> > >> >  # CONFIG_REGULATOR_FIXED_VOLTAGE is not set
> > >> >  # CONFIG_REGULATOR_VIRTUAL_CONSUMER is not set
> > >> >  # CONFIG_REGULATOR_BQ24022 is not set
> > >> > +CONFIG_REGULATOR_TWL4030=y
> > >> >  # CONFIG_UIO is not set
> > >> 
> > >> musb will still fail here if we don't have twl4030-usb enabled.
> > >> 
> > >> could you updated the patch to add that as well ??
> > >
> > > Updated. Maybe take a look and see if the USB options make sense
> > > to you? I could not enable OTG for some reason..
> > >
> > 
> > Probably because OTG depends on CONFIG_PM I think.
> 
> correct

I don't have a Beagle, so somebody please check this defconfig and enable
PM and OTG if possible.

Tony