From: Tony Lindgren <tony@atomide.com>
To: Kevin Hilman <khilman@deeprootsystems.com>
Cc: "Mark A. Greer" <mgreer@mvista.com>,
rtc-linux@googlegroups.com, David Brownell <david-b@pacbell.net>,
linux-omap@vger.kernel.org,
Davinci-linux-open-source@linux.davincidsp.com
Subject: Re: [PATCH v2] rtc: make rtc-omap driver ioremap its register space
Date: Tue, 22 Sep 2009 15:00:56 -0700 [thread overview]
Message-ID: <20090922220056.GG4919@atomide.com> (raw)
In-Reply-To: <87d45ievqa.fsf@deeprootsystems.com>
* Kevin Hilman <khilman@deeprootsystems.com> [090922 10:27]:
> "Mark A. Greer" <mgreer@mvista.com> writes:
>
> > From: Mark A. Greer <mgreer@mvista.com>
> >
> > The rtc-omap driver currently assumes that the rtc's
> > registers are at a fixed address and already mapped
> > into virtual memory space. Remove those assumptions
> > so the same driver can be used for similar devices
> > that reside at different physical addresses (e.g.,
> > TI's DA8xx/OMAP-L13x SoC's).
> >
> > Also allow the possibility for the timer and alarm
> > interrupts to use the same IRQ.
> >
> > Signed-off-by: Mark A. Greer <mgreer@mvista.com>
> > CC: David Brownell <david-b@pacbell.net>
>
> Acked-by: Kevin Hilman <khilman@deeprootsystems.com>
>
> for relevance to davinci platforms.
Acked-by: Tony Lindgren <tony@atomide.com>
>
> Kevin
>
>
> > ---
> > Sorry for the cross-posting but this is relevant to the different lists.
> >
> > This patch was tested on a da830 and a da850. It was only compiled
> > for an omap1 platform (don't have the hardware) but it should be low
> > risk. Note that the platform_device data is already set up in
> > arch/arm/mach-omap1/devices.c so it those platforms should
> > "Just Work(tm)".
> >
> > drivers/rtc/Kconfig | 7 ++++---
> > drivers/rtc/rtc-omap.c | 47 ++++++++++++++++++++++++++---------------------
> > 2 files changed, 30 insertions(+), 24 deletions(-)
> >
> > diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig
> > index 81adbdb..f06e885 100644
> > --- a/drivers/rtc/Kconfig
> > +++ b/drivers/rtc/Kconfig
> > @@ -539,10 +539,11 @@ comment "on-CPU RTC drivers"
> >
> > config RTC_DRV_OMAP
> > tristate "TI OMAP1"
> > - depends on ARCH_OMAP15XX || ARCH_OMAP16XX || ARCH_OMAP730
> > + depends on ARCH_OMAP15XX || ARCH_OMAP16XX || ARCH_OMAP730 || ARCH_DAVINCI_DA8XX
> > help
> > - Say "yes" here to support the real time clock on TI OMAP1 chips.
> > - This driver can also be built as a module called rtc-omap.
> > + Say "yes" here to support the real time clock on TI OMAP1 and
> > + DA8xx/OMAP-L13x chips. This driver can also be built as a
> > + module called rtc-omap.
> >
> > config RTC_DRV_S3C
> > tristate "Samsung S3C series SoC RTC"
> > diff --git a/drivers/rtc/rtc-omap.c b/drivers/rtc/rtc-omap.c
> > index bd1ce8e..aa418d5 100644
> > --- a/drivers/rtc/rtc-omap.c
> > +++ b/drivers/rtc/rtc-omap.c
> > @@ -87,9 +87,10 @@
> > #define OMAP_RTC_INTERRUPTS_IT_ALARM (1<<3)
> > #define OMAP_RTC_INTERRUPTS_IT_TIMER (1<<2)
> >
> > +static void __iomem *rtc_base;
> >
> > -#define rtc_read(addr) omap_readb(OMAP_RTC_BASE + (addr))
> > -#define rtc_write(val, addr) omap_writeb(val, OMAP_RTC_BASE + (addr))
> > +#define rtc_read(addr) __raw_readb(rtc_base + (addr))
> > +#define rtc_write(val, addr) __raw_writeb(val, rtc_base + (addr))
> >
> >
> > /* we rely on the rtc framework to handle locking (rtc->ops_lock),
> > @@ -330,32 +331,31 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> > return -ENOENT;
> > }
> >
> > - /* NOTE: using static mapping for RTC registers */
> > res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> > - if (res && res->start != OMAP_RTC_BASE) {
> > - pr_debug("%s: RTC registers at %08x, expected %08x\n",
> > - pdev->name, (unsigned) res->start, OMAP_RTC_BASE);
> > + if (!res) {
> > + pr_debug("%s: RTC resource data missing\n", pdev->name);
> > return -ENOENT;
> > }
> >
> > - if (res)
> > - mem = request_mem_region(res->start,
> > - res->end - res->start + 1,
> > - pdev->name);
> > - else
> > - mem = NULL;
> > + mem = request_mem_region(res->start, resource_size(res), pdev->name);
> > if (!mem) {
> > pr_debug("%s: RTC registers at %08x are not free\n",
> > - pdev->name, OMAP_RTC_BASE);
> > + pdev->name, res->start);
> > return -EBUSY;
> > }
> >
> > + rtc_base = ioremap(res->start, resource_size(res));
> > + if (!rtc_base) {
> > + pr_debug("%s: RTC registers can't be mapped\n", pdev->name);
> > + goto fail;
> > + }
> > +
> > rtc = rtc_device_register(pdev->name, &pdev->dev,
> > &omap_rtc_ops, THIS_MODULE);
> > if (IS_ERR(rtc)) {
> > pr_debug("%s: can't register RTC device, err %ld\n",
> > pdev->name, PTR_ERR(rtc));
> > - goto fail;
> > + goto fail0;
> > }
> > platform_set_drvdata(pdev, rtc);
> > dev_set_drvdata(&rtc->dev, mem);
> > @@ -380,13 +380,14 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> > dev_name(&rtc->dev), rtc)) {
> > pr_debug("%s: RTC timer interrupt IRQ%d already claimed\n",
> > pdev->name, omap_rtc_timer);
> > - goto fail0;
> > + goto fail1;
> > }
> > - if (request_irq(omap_rtc_alarm, rtc_irq, IRQF_DISABLED,
> > - dev_name(&rtc->dev), rtc)) {
> > + if ((omap_rtc_timer != omap_rtc_alarm) &&
> > + (request_irq(omap_rtc_alarm, rtc_irq, IRQF_DISABLED,
> > + dev_name(&rtc->dev), rtc))) {
> > pr_debug("%s: RTC alarm interrupt IRQ%d already claimed\n",
> > pdev->name, omap_rtc_alarm);
> > - goto fail1;
> > + goto fail2;
> > }
> >
> > /* On boards with split power, RTC_ON_NOFF won't reset the RTC */
> > @@ -419,10 +420,12 @@ static int __init omap_rtc_probe(struct platform_device *pdev)
> >
> > return 0;
> >
> > -fail1:
> > +fail2:
> > free_irq(omap_rtc_timer, NULL);
> > -fail0:
> > +fail1:
> > rtc_device_unregister(rtc);
> > +fail0:
> > + iounmap(rtc_base);
> > fail:
> > release_resource(mem);
> > return -EIO;
> > @@ -438,7 +441,9 @@ static int __exit omap_rtc_remove(struct platform_device *pdev)
> > rtc_write(0, OMAP_RTC_INTERRUPTS_REG);
> >
> > free_irq(omap_rtc_timer, rtc);
> > - free_irq(omap_rtc_alarm, rtc);
> > +
> > + if (omap_rtc_timer != omap_rtc_alarm)
> > + free_irq(omap_rtc_alarm, rtc);
> >
> > release_resource(dev_get_drvdata(&rtc->dev));
> > rtc_device_unregister(rtc);
> > --
> > 1.6.2.5.182.ga808d
> >
> > --
> > To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2009-09-22 22:01 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-09-17 0:04 [PATCH v2] rtc: make rtc-omap driver ioremap its register space Mark A. Greer
2009-09-22 17:26 ` Kevin Hilman
2009-09-22 22:00 ` Tony Lindgren [this message]
[not found] ` <20090917000458.GA6119-S3yzRvi4kHRa+ipTMWa7OQC/G2K4zDHf@public.gmane.org>
2009-09-17 4:02 ` David Brownell
2009-10-13 23:00 ` Mark A. Greer
2009-10-13 23:15 ` [rtc-linux] " Alessandro Zummo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090922220056.GG4919@atomide.com \
--to=tony@atomide.com \
--cc=Davinci-linux-open-source@linux.davincidsp.com \
--cc=david-b@pacbell.net \
--cc=khilman@deeprootsystems.com \
--cc=linux-omap@vger.kernel.org \
--cc=mgreer@mvista.com \
--cc=rtc-linux@googlegroups.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.