[U-Boot] kirkwood (openrd): saveenv will not work with environment in NAND

[Dieter Kiermaier <dk-arm-linux@gmx.de>]

Am Dienstag 29 September 2009 15:55:55 schrieb Dieter Kiermaier:
> Hi everybody,
> 
> I try to bring up fw_setenv / fw_printenv in linux kernel but first it want to start with u-boot itself.
> I built most recent u-boot-marvell git source and get a running u-boot with standard openrd configuration.
> So far so good.
> 

Hm, it looks like there is the whole nand system somewhat broken :(
Haven't seen it earlier, but:
U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42)
OpenRD_base

SoC: ? Kirkwood 88F6281_A0
DRAM: ?27535155593740288 MB
NAND: ?0 MiB
*** Warning - bad CRC or NAND, using default environment

In: ? ?serial
Out: ? serial
Err: ? serial
Net: ? egiga0
88E1116 Initialized on egiga0


But boot message state that there is no NAND detected!
So I assume that is the main cause for the not working saveenv command?
Cross checked it with marvell provided u-boot - this one works. So damaged hardware isn't the case.

Please could somebody check it, too?

Many thanks,
Dieter


> version says:
> ArtistaNET-III>> version
> 
> U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42)
> OpenRD_base
> 
> 
> But saveenv will not work as expected. setenv of new parameter will work but after saveenv and reboot
> the new parameter is lost and u-boot complains about wrong CRC again.
> 
> Any help would be very appreciated.
> 
> Dieter
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>