All of lore.kernel.org
 help / color / mirror / Atom feed
From: Wu Fengguang <fengguang.wu@intel.com>
To: Takashi Iwai <tiwai@suse.de>
Cc: "alsa-devel@alsa-project.org" <alsa-devel@alsa-project.org>,
	Shane W <shane-alsa@csy.ca>
Subject: Re: [PATCH 5/5] intelhdmi - dont power off HDA link
Date: Fri, 11 Dec 2009 20:15:11 +0800	[thread overview]
Message-ID: <20091211121511.GA12374@localhost> (raw)
In-Reply-To: <s5hhbryoum3.wl%tiwai@suse.de>

On Fri, Dec 11, 2009 at 03:08:52PM +0800, Takashi Iwai wrote:
> At Fri, 11 Dec 2009 12:28:37 +0800,
> Wu Fengguang wrote:
> > 
> > For codecs without EPSS support (G45/IbexPeak), the hotplug event will
> > be lost if the HDA is powered off during the time. After that the pin
> > presence detection verb returns inaccurate info.
> > 
> > So always power-on HDA link for !EPSS codecs.
> > 
> > Signed-off-by: Wu Fengguang <fengguang.wu@intel.com>
> 
> I think it'd be better to add a flag to hda_bus than hda_codec like
> the patch below (the change in patch_intelhdmi.c is not included).
> It's a bit ugly to change the module parameter from the driver side.

Good suggestion, thanks! Here is the updated patch.

---
intelhdmi - don't power off HDA link

For codecs without EPSS support (G45/IbexPeak), the hotplug event will
be lost if the HDA is powered off during the time. After that the pin
presence detection verb returns inaccurate info.

So always power-on HDA link for !EPSS codecs.

KarL offers the fact and Takashi recommends to flag hda_bus. Thanks!

Signed-off-by: Wu Fengguang <fengguang.wu@intel.com>
---
 sound/pci/hda/hda_codec.h       |    1 +
 sound/pci/hda/hda_intel.c       |    3 ++-
 sound/pci/hda/patch_intelhdmi.c |   11 +++++++++++
 3 files changed, 14 insertions(+), 1 deletion(-)

--- sound-2.6.orig/sound/pci/hda/hda_intel.c	2009-12-11 12:46:18.000000000 +0800
+++ sound-2.6/sound/pci/hda/hda_intel.c	2009-12-11 20:12:31.000000000 +0800
@@ -2082,7 +2082,8 @@ static void azx_power_notify(struct hda_
 	}
 	if (power_on)
 		azx_init_chip(chip);
-	else if (chip->running && power_save_controller)
+	else if (chip->running && power_save_controller &&
+		 !bus->power_keep_link_on)
 		azx_stop_chip(chip);
 }
 #endif /* CONFIG_SND_HDA_POWER_SAVE */
--- sound-2.6.orig/sound/pci/hda/patch_intelhdmi.c	2009-12-11 12:46:22.000000000 +0800
+++ sound-2.6/sound/pci/hda/patch_intelhdmi.c	2009-12-11 20:07:59.000000000 +0800
@@ -391,6 +391,17 @@ static int intel_hdmi_parse_codec(struct
 		}
 	}
 
+	/*
+	 * G45/IbexPeak don't support EPSS: the unsolicited pin hot plug event
+	 * can be lost and presence sense verb will become inaccurate if the
+	 * HDA link is powered off at hot plug or hw initialization time.
+	 */
+#ifdef CONFIG_SND_HDA_POWER_SAVE
+	if (!(snd_hda_param_read(codec, codec->afg, AC_PAR_POWER_STATE) &
+	      AC_PWRST_EPSS))
+		codec->bus->power_keep_link_on = 1;
+#endif
+
 	return 0;
 }
 
--- sound-2.6.orig/sound/pci/hda/hda_codec.h	2009-12-11 12:46:21.000000000 +0800
+++ sound-2.6/sound/pci/hda/hda_codec.h	2009-12-11 20:13:18.000000000 +0800
@@ -639,6 +639,7 @@ struct hda_bus {
 	unsigned int rirb_error:1;	/* error in codec communication */
 	unsigned int response_reset:1;	/* controller was reset */
 	unsigned int in_reset:1;	/* during reset operation */
+	unsigned int power_keep_link_on:1; /* don't power off HDA link */
 };
 
 /*

  reply	other threads:[~2009-12-11 12:15 UTC|newest]

Thread overview: 11+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2009-12-11  4:28 [PATCH 0/5] Intel HDMI fixes Wu Fengguang
2009-12-11  4:28 ` [PATCH 1/5] hda - show HBR(High Bit Rate) pin cap in procfs Wu Fengguang
2009-12-11  4:28 ` [PATCH 2/5] intelhdmi - accept DisplayPort pin Wu Fengguang
2009-12-11  4:28 ` [PATCH 3/5] intelhdmi - channel mapping applies to Pin Wu Fengguang
2009-12-11  4:28 ` [PATCH 4/5] intelhdmi - add channel mapping for typical configurations Wu Fengguang
2009-12-11  7:00   ` Takashi Iwai
2009-12-11 12:05     ` Wu Fengguang
2009-12-11  4:28 ` [PATCH 5/5] intelhdmi - dont power off HDA link Wu Fengguang
2009-12-11  7:08   ` Takashi Iwai
2009-12-11 12:15     ` Wu Fengguang [this message]
2009-12-11  7:10 ` [PATCH 0/5] Intel HDMI fixes Takashi Iwai

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20091211121511.GA12374@localhost \
    --to=fengguang.wu@intel.com \
    --cc=alsa-devel@alsa-project.org \
    --cc=shane-alsa@csy.ca \
    --cc=tiwai@suse.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.