Re: [PATCH 1/3] mfd: add STMPE811 core support

[Mark Brown <broonie@opensource.wolfsonmicro.com>]

On Fri, Jun 11, 2010 at 12:13:13PM +0200, Luotao Fu wrote:

> +	for_each_set_bit(bit, (unsigned long *)&int_stat, STMPE811_NUM_IRQ) {
> +		handler = stm->irqhandler[bit];
> +		data = stm->irqdata[bit];
> +		if (handler) {

You should be using genirq here - just call handle_nested_irq() if the
IRQ is asserted and let genirq manage the handler for you.

> +static irqreturn_t stmpe811_irq(int irq, void *data)
> +{
> +	struct stmpe811 *stm = data;
> +
> +	get_device(stm->dev);
> +	disable_irq_nosync(stm->irq);
> +	queue_work(stm->work_queue, &stm->irq_work);
> +
> +	return IRQ_HANDLED;
> +}

You should use request_threaded_irq() for the main IRQ - it will take
care of all this for you.


> +static struct i2c_device_id stmpe811_id_table[] = {
> +	{"stmpe811", 0x88},

Any reason for the 0x88 - you don't seem to use it anywhere?

> +int stmpe811_register_irq(struct stmpe811 *stm, int irq,
> +			  irq_handler_t handler, void *data);
> +int stmpe811_free_irq(struct stmpe811 *stm, int irq);

If you use genirq these can be dropped - this will also mean that
existing generic drivers using the standard GPIO and IRQ frameworks will
be able to use the chip without modification.