Re: ath5k problem with 2.6.35

[Thomas Fjellstrom <thomas@fjellstrom.ca>]

On August 23, 2010, John W. Linville wrote:
> On Sun, Aug 22, 2010 at 01:53:41AM -0600, Thomas Fjellstrom wrote:
> > On August 22, 2010, Thomas Fjellstrom wrote:
> > > Hi, I'm running 2.6.35, and my wireless card fails to initialize
> > > properly
> > 
> > > on boot. I get the following messages in dmesg:
> > Probably important, but I missed a couple lines:
> > > [    0.866525] ath5k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) ->
> > > IRQ 17 [    0.866536] ath5k 0000:02:00.0: setting latency timer to 64
> > > [    0.866571] ath5k 0000:02:00.0: registered as 'phy0'
> > > [    1.358241] ath: EEPROM regdomain: 0x67
> > > [    1.358242] ath: EEPROM indicates we should expect a direct regpair
> > > map [    1.358245] ath: Country alpha2 being used: 00
> > > [    1.358247] ath: Regpair used: 0x67
> > > 
> >    [    1.360589] phy0: Failed to initialize wep: -2
> > > 
> > > [    1.372021] ath5k phy0: can't register ieee80211 hw
> > > [    1.372080] ath5k 0000:02:00.0: PCI INT A disabled
> > > [    1.372084] ath5k: probe of 0000:02:00.0 failed with error -2
> 
> Did you enable fips mode?

I don't even know what that is, so no. At least I didn't do it. if wicd did, 
then yes.

> John


-- 
Thomas Fjellstrom
thomas@fjellstrom.ca