From: John Fastabend <john.r.fastabend@intel.com>
To: netdev@vger.kernel.org
Cc: jesse@nicira.com
Subject: [RFC][net-next-2.6 PATCH 1/4] net: consolidate 8021q tagging
Date: Thu, 21 Oct 2010 15:10:04 -0700 [thread overview]
Message-ID: <20101021221004.22906.58438.stgit@jf-dev1-dcblab> (raw)
Now that VLAN packets are tagged in dev_hard_start_xmit()
at the bottom of the stack we no longer need to tag them
in the 8021Q module (Except in the !VLAN_FLAG_REORDER_HDR
case).
This allows the accel path and non accel paths to be consolidated.
Here the vlan_tci in the skb is always set and we allow the
stack to add the actual tag in dev_hard_start_xmit().
Signed-off-by: John Fastabend <john.r.fastabend@intel.com>
---
net/8021q/vlan_dev.c | 105 +++-----------------------------------------------
1 files changed, 7 insertions(+), 98 deletions(-)
diff --git a/net/8021q/vlan_dev.c b/net/8021q/vlan_dev.c
index 14e3d1f..78b1618 100644
--- a/net/8021q/vlan_dev.c
+++ b/net/8021q/vlan_dev.c
@@ -326,24 +326,12 @@ static netdev_tx_t vlan_dev_hard_start_xmit(struct sk_buff *skb,
*/
if (veth->h_vlan_proto != htons(ETH_P_8021Q) ||
vlan_dev_info(dev)->flags & VLAN_FLAG_REORDER_HDR) {
- unsigned int orig_headroom = skb_headroom(skb);
u16 vlan_tci;
-
- vlan_dev_info(dev)->cnt_encap_on_xmit++;
-
vlan_tci = vlan_dev_info(dev)->vlan_id;
vlan_tci |= vlan_dev_get_egress_qos_mask(dev, skb);
- skb = __vlan_put_tag(skb, vlan_tci);
- if (!skb) {
- txq->tx_dropped++;
- return NETDEV_TX_OK;
- }
-
- if (orig_headroom < VLAN_HLEN)
- vlan_dev_info(dev)->cnt_inc_headroom_on_tx++;
+ skb = __vlan_hwaccel_put_tag(skb, vlan_tci);
}
-
skb_set_dev(skb, vlan_dev_info(dev)->real_dev);
len = skb->len;
ret = dev_queue_xmit(skb);
@@ -357,32 +345,6 @@ static netdev_tx_t vlan_dev_hard_start_xmit(struct sk_buff *skb,
return ret;
}
-static netdev_tx_t vlan_dev_hwaccel_hard_start_xmit(struct sk_buff *skb,
- struct net_device *dev)
-{
- int i = skb_get_queue_mapping(skb);
- struct netdev_queue *txq = netdev_get_tx_queue(dev, i);
- u16 vlan_tci;
- unsigned int len;
- int ret;
-
- vlan_tci = vlan_dev_info(dev)->vlan_id;
- vlan_tci |= vlan_dev_get_egress_qos_mask(dev, skb);
- skb = __vlan_hwaccel_put_tag(skb, vlan_tci);
-
- skb->dev = vlan_dev_info(dev)->real_dev;
- len = skb->len;
- ret = dev_queue_xmit(skb);
-
- if (likely(ret == NET_XMIT_SUCCESS || ret == NET_XMIT_CN)) {
- txq->tx_packets++;
- txq->tx_bytes += len;
- } else
- txq->tx_dropped++;
-
- return ret;
-}
-
static u16 vlan_dev_select_queue(struct net_device *dev, struct sk_buff *skb)
{
struct net_device *rdev = vlan_dev_info(dev)->real_dev;
@@ -719,8 +681,7 @@ static const struct header_ops vlan_header_ops = {
.parse = eth_header_parse,
};
-static const struct net_device_ops vlan_netdev_ops, vlan_netdev_accel_ops,
- vlan_netdev_ops_sq, vlan_netdev_accel_ops_sq;
+static const struct net_device_ops vlan_netdev_ops, vlan_netdev_ops_sq;
static int vlan_dev_init(struct net_device *dev)
{
@@ -755,19 +716,16 @@ static int vlan_dev_init(struct net_device *dev)
if (real_dev->features & NETIF_F_HW_VLAN_TX) {
dev->header_ops = real_dev->header_ops;
dev->hard_header_len = real_dev->hard_header_len;
- if (real_dev->netdev_ops->ndo_select_queue)
- dev->netdev_ops = &vlan_netdev_accel_ops_sq;
- else
- dev->netdev_ops = &vlan_netdev_accel_ops;
} else {
dev->header_ops = &vlan_header_ops;
dev->hard_header_len = real_dev->hard_header_len + VLAN_HLEN;
- if (real_dev->netdev_ops->ndo_select_queue)
- dev->netdev_ops = &vlan_netdev_ops_sq;
- else
- dev->netdev_ops = &vlan_netdev_ops;
}
+ if (real_dev->netdev_ops->ndo_select_queue)
+ dev->netdev_ops = &vlan_netdev_ops_sq;
+ else
+ dev->netdev_ops = &vlan_netdev_ops;
+
if (is_vlan_dev(real_dev))
subclass = 1;
@@ -908,30 +866,6 @@ static const struct net_device_ops vlan_netdev_ops = {
#endif
};
-static const struct net_device_ops vlan_netdev_accel_ops = {
- .ndo_change_mtu = vlan_dev_change_mtu,
- .ndo_init = vlan_dev_init,
- .ndo_uninit = vlan_dev_uninit,
- .ndo_open = vlan_dev_open,
- .ndo_stop = vlan_dev_stop,
- .ndo_start_xmit = vlan_dev_hwaccel_hard_start_xmit,
- .ndo_validate_addr = eth_validate_addr,
- .ndo_set_mac_address = vlan_dev_set_mac_address,
- .ndo_set_rx_mode = vlan_dev_set_rx_mode,
- .ndo_set_multicast_list = vlan_dev_set_rx_mode,
- .ndo_change_rx_flags = vlan_dev_change_rx_flags,
- .ndo_do_ioctl = vlan_dev_ioctl,
- .ndo_neigh_setup = vlan_dev_neigh_setup,
- .ndo_get_stats64 = vlan_dev_get_stats64,
-#if defined(CONFIG_FCOE) || defined(CONFIG_FCOE_MODULE)
- .ndo_fcoe_ddp_setup = vlan_dev_fcoe_ddp_setup,
- .ndo_fcoe_ddp_done = vlan_dev_fcoe_ddp_done,
- .ndo_fcoe_enable = vlan_dev_fcoe_enable,
- .ndo_fcoe_disable = vlan_dev_fcoe_disable,
- .ndo_fcoe_get_wwn = vlan_dev_fcoe_get_wwn,
-#endif
-};
-
static const struct net_device_ops vlan_netdev_ops_sq = {
.ndo_select_queue = vlan_dev_select_queue,
.ndo_change_mtu = vlan_dev_change_mtu,
@@ -957,31 +891,6 @@ static const struct net_device_ops vlan_netdev_ops_sq = {
#endif
};
-static const struct net_device_ops vlan_netdev_accel_ops_sq = {
- .ndo_select_queue = vlan_dev_select_queue,
- .ndo_change_mtu = vlan_dev_change_mtu,
- .ndo_init = vlan_dev_init,
- .ndo_uninit = vlan_dev_uninit,
- .ndo_open = vlan_dev_open,
- .ndo_stop = vlan_dev_stop,
- .ndo_start_xmit = vlan_dev_hwaccel_hard_start_xmit,
- .ndo_validate_addr = eth_validate_addr,
- .ndo_set_mac_address = vlan_dev_set_mac_address,
- .ndo_set_rx_mode = vlan_dev_set_rx_mode,
- .ndo_set_multicast_list = vlan_dev_set_rx_mode,
- .ndo_change_rx_flags = vlan_dev_change_rx_flags,
- .ndo_do_ioctl = vlan_dev_ioctl,
- .ndo_neigh_setup = vlan_dev_neigh_setup,
- .ndo_get_stats64 = vlan_dev_get_stats64,
-#if defined(CONFIG_FCOE) || defined(CONFIG_FCOE_MODULE)
- .ndo_fcoe_ddp_setup = vlan_dev_fcoe_ddp_setup,
- .ndo_fcoe_ddp_done = vlan_dev_fcoe_ddp_done,
- .ndo_fcoe_enable = vlan_dev_fcoe_enable,
- .ndo_fcoe_disable = vlan_dev_fcoe_disable,
- .ndo_fcoe_get_wwn = vlan_dev_fcoe_get_wwn,
-#endif
-};
-
void vlan_setup(struct net_device *dev)
{
ether_setup(dev);
next reply other threads:[~2010-10-21 22:11 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-10-21 22:10 John Fastabend [this message]
2010-10-21 22:10 ` [RFC][net-next-2.6 PATCH 2/4] net: 8021Q consolidate header_ops routines John Fastabend
2010-10-25 22:44 ` Jesse Gross
2010-11-04 0:47 ` Jesse Gross
2010-11-04 13:43 ` John Fastabend
2010-11-04 18:26 ` Jesse Gross
2010-10-21 22:10 ` [RFC][net-next-2.6 PATCH 3/4] ethtool: set hard_header_len using ETH_FLAG_{TX|RX}VLAN John Fastabend
2010-10-22 13:00 ` Ben Hutchings
2010-10-25 22:45 ` Jesse Gross
2010-10-26 21:58 ` John Fastabend
2010-10-21 22:10 ` [RFC][net-next-2.6 PATCH 4/4] net: remove check for headroom in vlan_dev_create John Fastabend
2010-10-25 22:45 ` Jesse Gross
2010-10-26 22:05 ` John Fastabend
2010-10-27 2:07 ` Jesse Gross
2010-10-25 22:44 ` [RFC][net-next-2.6 PATCH 1/4] net: consolidate 8021q tagging Jesse Gross
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20101021221004.22906.58438.stgit@jf-dev1-dcblab \
--to=john.r.fastabend@intel.com \
--cc=jesse@nicira.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.