[U-Boot] [PATCH 1/1] MX5:MX53: support for Freescale MX53LOCO

[Marek Vasut <marek.vasut@gmail.com>]

> Hi Stefano,
> 
> I cloned from http://git.denx.de/u-boot-imx.git into local directory
> "/home/budm/Mamaku-Boot/". Then configured for mx53loco_config without a
> problem but the make failed.
> 
> I am using the same tools as the previous case when I was successful in
> building but could not get it to run, etc.
> 
> The command line I use is: make ARCH=arm CROSS_COMPILE=arm-none-eabi-
> u-boot.imx
> 
> I am attaching two log files:
> 
> 	1. bould.log 		- containing all output just before the
> error
> 	2. build_failure.log	- containing the error output
> 
> Any suggestion is appreciated.
> 
> -bud
> 
> -----Original Message-----
> From: Stefano Babic [mailto:sbabic at denx.de]
> Sent: Friday, 3 February 2012 7:30 p.m.
> To: Bud Miljkovic
> Cc: Jason Liu; sbabic at denx.de; u-boot at lists.denx.de
> Subject: Re: [U-Boot] [PATCH 1/1] MX5:MX53: support for Freescale
> MX53LOCO
> 
> On 03/02/2012 06:58, Jason Liu wrote:
> Hi Bud,
> 
> >> I have cloned yesterday http://git.denx.de/u-boot.git on to my local
> >> machine and from there selected the v2011.12-rc3 tag.  Then I
> 
> configured
> 
> >> the mx53loco board and successfully build u-boot.imx, copied the
> 
> image
> 
> >> to a SD card and powered it up.  What I then got on the serial port
> > 
> >> terminal was as follows:
> > I have fixed this issue by a recent commit which is queened in
> > u-boot-imx and you can refer to
> > the patch here: http://patchwork.ozlabs.org/patch/138761/
> 
> You can also clone from http://git.denx.de/u-boot-imx.git, Jason's patch
> was already merged.
> 
> Best regards,
> Stefano Babic

There was patch for that in the ml recently I think ... look for tbclk.

M