From: andrew@lunn.ch (Andrew Lunn)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 0/5] more clk-next fixes
Date: Tue, 8 May 2012 09:20:31 +0200 [thread overview]
Message-ID: <20120508072031.GC26076@lunn.ch> (raw)
In-Reply-To: <1336367310-5140-1-git-send-email-mturquette@linaro.org>
> Note that the Orion patches aren't here, but I figure that Andrew L.
> probably wants to check those against the final clk-next before I pull
> them.
Hi Mike
Here is a pull request. There is only one small change since the
previous version. The last patch no longer has
select COMMON_CLK_DISABLE_UNUSED.
Thanks
Andrew
The following changes since commit d49d10779b9b9d1c07dc61bf58a7995835b7d32f:
clk: clk_set_rate() must fail if CLK_SET_RATE_GATE is set and clk is enabled (2012-05-07 09:57:58 +0200)
are available in the git repository at:
git://github.com/lunn/orion-clk.git v3.4-rc5-clk-next-orion-v2
Andrew Lunn (14):
[ARM: Orion] Add clocks using the generic clk infrastructure.
[ARM: Orion: SPI] Add clk/clkdev support.
[ARM: Orion: Eth] Add clk/clkdev support.
[ARM: Orion: WDT] Add clk/clkdev support
[ARM: Orion: UART] Get the clock rate via clk_get_rate().
[ARM: Orion: SATA] Add per channel clk/clkdev support.
[ARM: Orion: EHCI] Add support for enabling clocks
[ARM: Orion: NAND] Add support for clk, if there is one.
[ARM: Orion: SDIO] Add support for clk.
[ARM: Orion: CESA] Add support for clk
[ARM: Orion: XOR] Add support for clk
[ARM: Orion: PCIE] Add support for clk
[ARM: Orion: Audio] Add clk/clkdev support
[ARM: Kirkwood] Replace clock gating
arch/arm/Kconfig | 2 +
arch/arm/mach-dove/common.c | 40 ++-
arch/arm/mach-dove/dove-db-setup.c | 1 -
arch/arm/mach-kirkwood/board-dreamplug.c | 1 -
arch/arm/mach-kirkwood/board-dt.c | 3 +
arch/arm/mach-kirkwood/common.c | 274 ++++++++++++++-------
arch/arm/mach-kirkwood/common.h | 1 +
arch/arm/mach-kirkwood/include/mach/bridge-regs.h | 16 ++
arch/arm/mach-kirkwood/mv88f6281gtw_ge-setup.c | 1 -
arch/arm/mach-kirkwood/pcie.c | 25 ++-
arch/arm/mach-kirkwood/rd88f6192-nas-setup.c | 1 -
arch/arm/mach-kirkwood/t5325-setup.c | 1 -
arch/arm/mach-kirkwood/tsx1x-common.c | 1 -
arch/arm/mach-mv78xx0/common.c | 45 +++--
arch/arm/mach-orion5x/common.c | 27 ++-
arch/arm/mach-orion5x/rd88f6183ap-ge-setup.c | 1 -
arch/arm/plat-orion/common.c | 104 +++++----
arch/arm/plat-orion/include/plat/common.h | 34 ++--
arch/arm/plat-orion/include/plat/orion_wdt.h | 18 --
arch/arm/plat-orion/pcie.c | 4 +-
drivers/ata/sata_mv.c | 40 +++-
drivers/crypto/mv_cesa.c | 14 +
drivers/dma/mv_xor.c | 15 ++
drivers/dma/mv_xor.h | 1 +
drivers/mmc/host/mvsdio.c | 14 +
drivers/mtd/nand/orion_nand.c | 18 ++
drivers/net/ethernet/marvell/mv643xx_eth.c | 42 +++-
drivers/spi/spi-orion.c | 30 ++-
drivers/usb/host/ehci-orion.c | 16 ++
drivers/watchdog/orion_wdt.c | 16 +-
include/linux/mv643xx_eth.h | 1 -
include/linux/spi/orion_spi.h | 17 --
sound/soc/kirkwood/kirkwood-i2s.c | 13 +
sound/soc/kirkwood/kirkwood.h | 1 +
34 files changed, 575 insertions(+), 263 deletions(-)
delete mode 100644 arch/arm/plat-orion/include/plat/orion_wdt.h
delete mode 100644 include/linux/spi/orion_spi.h
next prev parent reply other threads:[~2012-05-08 7:20 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-05-07 5:08 [PATCH 0/5] more clk-next fixes Mike Turquette
2012-05-07 5:08 ` [PATCH 1/5] MAINTAINERS: add entry for common clk framework Mike Turquette
2012-05-07 5:08 ` [PATCH 2/5] clk: prevent spurious parent rate propagation Mike Turquette
2012-05-07 7:58 ` Sascha Hauer
2012-05-07 17:34 ` Turquette, Mike
2012-05-07 5:08 ` [PATCH 3/5] clk: remove COMMON_CLK_DISABLE_UNUSED Mike Turquette
2012-05-07 19:31 ` Saravana Kannan
2012-05-07 5:08 ` [PATCH 4/5] clk: mux: assign init data Mike Turquette
2012-05-07 5:08 ` [PATCH 5/5] clk: add a fixed factor clock Mike Turquette
2012-05-07 19:54 ` Saravana Kannan
2012-05-07 20:14 ` Turquette, Mike
2012-05-07 20:26 ` Saravana Kannan
2012-05-08 7:20 ` Andrew Lunn [this message]
2012-05-08 16:12 ` [PATCH 0/5] more clk-next fixes Shawn Guo
2012-05-08 17:33 ` Turquette, Mike
2012-05-08 21:35 ` Turquette, Mike
2012-05-11 14:39 ` Arnd Bergmann
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20120508072031.GC26076@lunn.ch \
--to=andrew@lunn.ch \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.