Re: [PATCH v9 01/13] usb: musb: dsps: add phy control logic to glue

[Tony Lindgren <tony@atomide.com>]

* Ravi Babu <ravibabu@ti.com> [120831 04:10]:
> --- a/arch/arm/plat-omap/include/plat/usb.h
> +++ b/arch/arm/plat-omap/include/plat/usb.h
> @@ -95,7 +95,6 @@ extern void am35x_musb_reset(void);
>  extern void am35x_musb_phy_power(u8 on);
>  extern void am35x_musb_clear_irq(void);
>  extern void am35x_set_mode(u8 musb_mode);
> -extern void ti81xx_musb_phy_power(u8 on);
>  
>  /* AM35x */
>  /* USB 2.0 PHY Control */
> @@ -120,8 +119,8 @@ extern void ti81xx_musb_phy_power(u8 on);
>  #define CONF2_DATPOL		(1 << 1)
>  
>  /* TI81XX specific definitions */
> -#define USBCTRL0	0x620
> -#define USBSTAT0	0x624
> +#define MUSB_USBSS_REV_816X	0x9
> +#define MUSB_USBSS_REV_814X	0xb
>  
>  /* TI816X PHY controls bits */
>  #define TI816X_USBPHY0_NORMAL_MODE	(1 << 0)

This file needs to move to include/linux/platform_data/usb-omap.h
as it's blocking the ARM single zImage changes so some coordination is
required here. Felipe, can you do a minimal immutable branch with just
one patch against v3.6-rc3 that move the header so I can pull in too?

Regards,

Tony