Re: [PATCH] EHCI/Xen: propagate controller reset information to hypervisor

[Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>]

On Tue, Sep 18, 2012 at 04:06:49PM +0100, Greg KH wrote:
> On Tue, Sep 18, 2012 at 10:42:30AM -0400, Konrad Rzeszutek Wilk wrote:
> > On Tue, Sep 18, 2012 at 12:23:02PM +0100, Jan Beulich wrote:
> > > Just like for the in-tree early console debug port driver, the
> > > hypervisor - when using a debug port based console - also needs to be
> > > told about controller resets, so it can suppress using and then
> > > re-initialize the debug port accordingly.
> > > 
> > > Other than the in-tree driver, the hypervisor driver actually cares
> > > about doing this only for the device where the debug is port actually
> > > in use, i.e. it needs to be told the coordinates of the device being
> > > reset (quite obviously, leveraging the addition done for that would
> > > likely benefit the in-tree driver too).
> > > 
> > > Signed-off-by: Jan Beulich <jbeulich@suse.com>
> > 
> > Acked-by: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
> > 
> > on the *xen* parts.
> 
> So, I'm guessing this should go in through the USB tree?  If there are
> no objections, I'll do that.

No objections. Thank you.