Re: [PATCH v6 1/2] PCI-Express Non-Transparent Bridge Support

[Greg KH <gregkh@linuxfoundation.org>]

On Fri, Nov 16, 2012 at 07:27:12PM -0700, Jon Mason wrote:
> A PCI-Express non-transparent bridge (NTB) is a point-to-point PCIe bus
> connecting 2 systems, providing electrical isolation between the two subsystems.
> A non-transparent bridge is functionally similar to a transparent bridge except
> that both sides of the bridge have their own independent address domains.  The
> host on one side of the bridge will not have the visibility of the complete
> memory or I/O space on the other side of the bridge.  To communicate across the
> non-transparent bridge, each NTB endpoint has one (or more) apertures exposed to
> the local system.  Writes to these apertures are mirrored to memory on the
> remote system.  Communications can also occur through the use of doorbell
> registers that initiate interrupts to the alternate domain, and scratch-pad
> registers accessible from both sides.
> 
> The NTB device driver is needed to configure these memory windows, doorbell, and
> scratch-pad registers as well as use them in such a way as they can be turned
> into a viable communication channel to the remote system.  ntb_hw.[ch]
> determines the usage model (NTB to NTB or NTB to Root Port) and abstracts away
> the underlying hardware to provide access and a common interface to the doorbell
> registers, scratch pads, and memory windows.  These hardware interfaces are
> exported so that other, non-mainlined kernel drivers can access these.
> ntb_transport.[ch] also uses the exported interfaces in ntb_hw.[ch] to setup a
> communication channel(s) and provide a reliable way of transferring data from
> one side to the other, which it then exports so that "client" drivers can access
> them.  These client drivers are used to provide a standard kernel interface
> (i.e., Ethernet device) to NTB, such that Linux can transfer data from one
> system to the other in a standard way.
> 
> Signed-off-by: Jon Mason <jon.mason@intel.com>
> Reviewed-by: Nicholas Bellinger <nab@linux-iscsi.org>

Sorry for the very long delay, I've now applied these two patches,
thanks for the cleanups and changes from the original versions.

But, I now get the following build warning, so can you send a follow-on
patch that fixes it up before you start getting angry emails from the
0-day build bot?

drivers/ntb/ntb_transport.c: In function ‘ntb_transport_rx’:
drivers/ntb/ntb_transport.c:895:7: warning: ‘offset’ may be used uninitialized in this function [-Wuninitialized]
drivers/ntb/ntb_transport.c:891:8: note: ‘offset’ was declared here


thanks,

greg k-h