Re: [Qemu-devel] [PATCH v6 11/24] hw/nand.c: correct the sense of the BUSY/READY status bit

["Edgar E. Iglesias" <edgar.iglesias@gmail.com>]

On Thu, Mar 07, 2013 at 12:11:51PM +1000, Peter Crosthwaite wrote:
> Hi Kuo Jung, Peter,
> 
> This patch fixes bugs for us in Zynq Nand (cc Wendy Liang). Can we get
> a cherry pick of this?

I've applied this one.

Thanks,
Edgar


> 
> Regards,
> Peter
> 
> On Wed, Mar 6, 2013 at 5:27 PM, Kuo-Jung Su <dantesu@gmail.com> wrote:
> > The BIT6 of Status Register(SR):
> >
> > SR[6] behaves the same as R/B# pin
> >     SR[6] = 0 indicates the device is busy;
> >     SR[6] = 1 means the device is ready
> >
> > Some NAND flash controller (i.e. ftnandc021) relies on the SR[6]
> > to determine if the NAND flash erase/program is success or error timeout.
> >
> > P.S:
> > The exmaple NAND flash datasheet could be found at following link:
> > http://www.mxic.com.tw/QuickPlace/hq/PageLibrary4825740B00298A3B.nsf/h_Index/8FEA549237D2F7674825795800104C26/$File/MX30LF1G08AA,%203V,%201Gb,%20v1.1.pdf
> >
> > Signed-off-by: Kuo-Jung Su <dantesu@gmail.com>
> 
> Reviewed-by: Peter Crosthwaite <peter.crosthwaite@xilinx.com>
> 
> > ---
> >  hw/nand.c |    3 ++-
> >  1 file changed, 2 insertions(+), 1 deletion(-)
> >
> > diff --git a/hw/nand.c b/hw/nand.c
> > index 4a71265..61e918f 100644
> > --- a/hw/nand.c
> > +++ b/hw/nand.c
> > @@ -46,7 +46,7 @@
> >  # define NAND_IOSTATUS_PLANE1  (1 << 2)
> >  # define NAND_IOSTATUS_PLANE2  (1 << 3)
> >  # define NAND_IOSTATUS_PLANE3  (1 << 4)
> > -# define NAND_IOSTATUS_BUSY    (1 << 6)
> > +# define NAND_IOSTATUS_READY    (1 << 6)
> >  # define NAND_IOSTATUS_UNPROTCT        (1 << 7)
> >
> >  # define MAX_PAGE              0x800
> > @@ -231,6 +231,7 @@ static void nand_reset(DeviceState *dev)
> >      s->iolen = 0;
> >      s->offset = 0;
> >      s->status &= NAND_IOSTATUS_UNPROTCT;
> > +    s->status |= NAND_IOSTATUS_READY;
> >  }
> >
> >  static inline void nand_pushio_byte(NANDFlashState *s, uint8_t value)
> > --
> > 1.7.9.5
> >
> >