[PATCH V2] ARM: mx5: Add support for DENX M53EVK

[marex@denx.de (Marek Vasut)]

Dear Shawn Guo,

> On Mon, Apr 22, 2013 at 11:23:47PM +0200, Marek Vasut wrote:
> > This patch adds support for the DENX M53EVK board. The board currently
> > supports NAND, Ethernet, UART, CAN, I2C.
> > 
> > Signed-off-by: Marek Vasut <marex@denx.de>
> > Cc: Fabio Estevam <fabio.estevam@freescale.com>
> > Cc: Shawn Guo <shawn.guo@linaro.org>
> > ---
> > 
> >  arch/arm/boot/dts/Makefile         |    1 +
> >  arch/arm/boot/dts/imx53-m53evk.dts |  259
> >  ++++++++++++++++++++++++++++++++++++ 2 files changed, 260 insertions(+)
> >  create mode 100644 arch/arm/boot/dts/imx53-m53evk.dts
> > 
> > V2: - Rebase on top of Shawn's patch:
> >       "[PATCH] ARM: imx: move imx53-qsb audio codec clk lookup into DT"
> >     
> >     - Use BGR666 format on LCD, this makes it depend on:
> >       "[PATCH V2] video: imx: Add BGR666 support for parallel display"
> 
> Does it hurt if I just go ahead to apply the patch?  Or do I have to
> wait for above patch goes in?

The LCD will fail to probe, but other than that, it will work OK.

Best regards,
Marek Vasut