From: Edward Seyler <epseyler@gmail.com>
To: Emmanuel Grumbach <egrumbach@gmail.com>
Cc: linux-wireless <linux-wireless@vger.kernel.org>
Subject: Re: Intel Centrino Wireless-N 2200 Tech Support
Date: Tue, 11 Jun 2013 23:04:06 -0500 [thread overview]
Message-ID: <20130612040406.GA8429@GregoriusMagnus.arch> (raw)
In-Reply-To: <CANUX_P0ddkfEY+hxir8=PGH1ocS5FQRFwvrm2otj3eTUkwJ+Gw@mail.gmail.com>
>
> This is really weird...
> Can you compile with CONFIG_IWLWIFI_DEBUG?
> I will then need a few debug prints.
> I recently changed this flow to speed up the fw loading process on
> platform that can afford a bit amount of DMA, but I just tested it
> (again) and it works even if there is not big DMA chunk available.
I compiled with CONFIG_IWLWIFI_DEBUG. I also absent mindedly enabled CONFIG_IWLWIFI_DEBUG_EXPERIMENTAL_UCODE--please let me know if you do not want this. I can provide other debugging output, but I am sending this now in case I cannot respond promptly.
# echo 0xFFFFFFFF > /sys/module/iwlwifi/parameters/debug
# dmesg | grep iwl
[ 10.116748] iwlwifi 0000:03:00.0: irq 43 for MSI/MSI-X
[ 10.234866] iwlwifi 0000:03:00.0: loaded firmware version 18.168.6.1
[ 10.362940] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEBUG enabled
[ 10.362952] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEBUGFS disabled
[ 10.362957] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEVICE_TRACING enabled
[ 10.362963] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEVICE_TESTMODE disabled
[ 10.362967] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_P2P disabled
[ 10.362974] iwlwifi 0000:03:00.0: Detected Intel(R) Centrino(R) Wireless-N 2200 BGN, REV=0x104
[ 10.363003] iwlwifi 0000:03:00.0: L1 Disabled; Enabling L0S
[ 10.377474] ieee80211 phy0: Selected rate control algorithm 'iwl-agn-rs'
[ 1180.920142] iwlwifi 0000:03:00.0: U iwlagn_mac_start enter
[ 1180.920152] iwlwifi 0000:03:00.0: I iwl_prep_station Add STA to driver ID 15: ff:ff:ff:ff:ff:ff
[ 1180.920158] iwlwifi 0000:03:00.0: I iwl_prep_station Add STA to driver ID 14: ff:ff:ff:ff:ff:ff
[ 1180.920163] iwlwifi 0000:03:00.0: U iwl_pcie_prepare_card_hw iwl_trans_prepare_card_hw enter
[ 1180.920171] iwlwifi 0000:03:00.0: U iwl_pcie_set_hw_ready hardware ready
[ 1180.920173] iwlwifi 0000:03:00.0: U iwl_enable_rfkill_int Enabling rfkill interrupt
[ 1180.920180] iwlwifi 0000:03:00.0: U iwl_pcie_apm_init Init card's basic functions
[ 1180.920196] iwlwifi 0000:03:00.0: L1 Disabled; Enabling L0S
[ 1180.928171] iwlwifi 0000:03:00.0: Radio type=0x2-0x0-0x0
[ 1180.929423] iwlwifi 0000:03:00.0: U iwl_enable_interrupts Enabling interrupts
[ 1180.929431] iwlwifi 0000:03:00.0: U iwl_pcie_load_section [0] uCode section being loaded...
[ 1185.926627] iwlwifi 0000:03:00.0: Failed to load firmware chunk!
[ 1185.926967] iwlwifi 0000:03:00.0: Could not load the [0] uCode section
[ 1185.927256] iwlwifi 0000:03:00.0: U iwl_disable_interrupts Disabled interrupts
[ 1185.927442] iwlwifi 0000:03:00.0: U iwl_pcie_apm_stop Stop card, put in low power state
[ 1185.927449] iwlwifi 0000:03:00.0: U iwl_pcie_apm_stop_master stop master
[ 1185.927465] iwlwifi 0000:03:00.0: U iwl_disable_interrupts Disabled interrupts
[ 1185.927467] iwlwifi 0000:03:00.0: U iwl_enable_rfkill_int Enabling rfkill interrupt
[ 1185.927470] iwlwifi 0000:03:00.0: Failed to run INIT ucode: -110
[ 1185.927712] iwlwifi 0000:03:00.0: U iwl_down iwlwifi is going down
[ 1185.927715] iwlwifi 0000:03:00.0: U iwl_scan_cancel_timeout Scan cancel timeout
[ 1185.927718] iwlwifi 0000:03:00.0: U iwl_do_scan_abort Not performing scan to abort
[ 1185.927721] iwlwifi 0000:03:00.0: U iwl_clear_ucode_stations Clearing ucode stations in driver
[ 1185.927725] iwlwifi 0000:03:00.0: U iwl_clear_ucode_stations No active stations found to be cleared
[ 1185.927733] iwlwifi 0000:03:00.0: U iwl_disable_interrupts Disabled interrupts
[ 1185.927738] iwlwifi 0000:03:00.0: U iwl_pcie_apm_stop Stop card, put in low power state
[ 1185.927744] iwlwifi 0000:03:00.0: U iwl_pcie_apm_stop_master stop master
[ 1185.927759] iwlwifi 0000:03:00.0: U iwl_disable_interrupts Disabled interrupts
[ 1185.927761] iwlwifi 0000:03:00.0: U iwl_enable_rfkill_int Enabling rfkill interrupt
[ 1185.927763] iwlwifi 0000:03:00.0: Unable to initialize device.
prev parent reply other threads:[~2013-06-12 4:04 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-06-11 4:28 Intel Centrino Wireless-N 2200 Tech Support Edward Seyler
2013-06-11 5:41 ` Emmanuel Grumbach
2013-06-12 4:04 ` Edward Seyler [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130612040406.GA8429@GregoriusMagnus.arch \
--to=epseyler@gmail.com \
--cc=egrumbach@gmail.com \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.