[U-Boot] [PATCH] mx6: Add IOMUX_CONFIG_SION flag to all GPIO pins

[Marek Vasut <marex@denx.de>]

Dear Otavio Salvador,

> On Tue, Oct 1, 2013 at 5:33 AM, Stefano Babic <sbabic@denx.de> wrote:
> > Hi Otavio,
> > 
> > On 30/09/2013 00:15, Otavio Salvador wrote:
> >> The IOMUX_CONFIG_SION allows for reading PAD value from PSR register.
> >> 
> >> The following quote from the datasheet:
> >> 
> >> ,----
> >> 
> >> | ...
> >> | 28.4.2.2 GPIO Write Mode
> >> | The programming sequence for driving output signals should be as
> >> | follows: 1. Configure IOMUX to select GPIO mode (Via IOMUXC), also
> >> | enable SION if need to read loopback pad value through PSR
> >> | 2. Configure GPIO direction register to output (GPIO_GDIR[GDIR] set to
> >> | 1b). 3. Write value to data register (GPIO_DR).
> >> | ...
> >> 
> >> `----
> >> 
> >> This fixes the gpio_get_value to properly work when a GPIO is set for
> >> output and has no conflicts.
> >> 
> >> Thanks for Beno?t Th?baudeau <benoit.thebaudeau@advansee.com>, Fabio
> >> Estevam <fabio.estevam@freescale.com> and Eric B?nard
> >> <eric@eukrea.com> for helping to properly trace this down.
> >> 
> >> Signed-off-by: Otavio Salvador <otavio@ossystems.com.br>
> >> ---
> > 
> > I come later in the discussion, but I see you all have found the
> > solution ;-).
> > 
> > I suggest you add in the commit message that this patch is only for
> > i.MX6 (if you do not plan to extend it to the other i.MXes...), so that
> > we can track that the same must be done also for the other SOCs.
> 
> I think this is clear from the commit prefix.

The commit message should be ARM: mx6: or such btw.

It'd be nice to fix it up for MX5 as well so we're consistent.

> I am under heavy load now and I cannot check their datasheet to verify
> if they all need this or not.
> 
> If someone does not does it, I can take a look for sure.




Best regards,
Marek Vasut