[U-Boot] [PATCH v4 00/29] zynq: More boards support

[Albert ARIBAUD <albert.u.boot@aribaud.net>]

Hi Jagannadha,

On Wed, 8 Jan 2014 15:53:07 +0530, Jagannadha Sutradharudu Teki
<jagannadha.sutradharudu-teki@xilinx.com> wrote:

> These changes are from u-boot-xlnx.git repo from git.xilinx.com
> and in addition of basic fdt support. This repo is well tested
> on xilinx zynq platform, hence pushing the same on upstream.
> 
> Excluded qspi and nand changes from previous series.
> 
> Please note that all this series available in u-boot-spi.git/master-xlnx
> repo.
> 
> --
> Thanks,
> Jagan.
> 
> Changes for v4:
> 	- rebase to master
> 	- Removed CONFIG_SYS_NO_FLASH in zynq-common.h

As the series was rebased tu u-boot/master, not u-boot-arm/master,
all patches adding board support failed to apply properly due to
boards.cfg differences.

I did resolve these manually, but at build-test time, all Zynq boards
failed with "Makefile:11: *** Please define CONFIG_DEFAULT_DEVICE_TREE
in your board header file.  Stop." -- and were the only ones to do so.

Jagan, can you look into this and produce a v5 which can build on ARM?

Amicalement,
-- 
Albert.